James Engineering Ltd. products

Removes plough pans. Reduces cultivation time to form seedbed. Combines aeration and cultivation in one pass. Increase oxygen supply to the soil. Improves soil water storage. Minimises breakdown of soil structure. Increases crop yields and profit.

The James Soil Aerator was manufactured to overcome the compaction of soil structures which result in excess moisture on pasture surfaces, shallow root systems and restricted plant growth.

The James Heavy Duty Mole plough is designed to transfer ground water to field tiles or open drains in soils where there is good clay subsoil. The mole plough forms a 60mm channel in the clay at a depth of approximately 46cm providing drainage.

The James Heavy Duty Dual Mole plough is designed to transfer ground water to field tiles or open drains in soils where there is good clay subsoil. The mole plough forms a 60mm channel in the clay at a depth of approximately 46cm providing drainage.

The James Super Ripper is designed for heavy duty ripping using 100hp plus tractors and has four working options. Tools not in use are simply lifted and locked out of the way.

Designed for cropping operators, the pre-ripper aerates and shatters compacted soils and plough pans immediately in front of the power harrow. This operation reduces the workload and horsepower required to operate the power harrow. Fuel savings of up to 20% have been achieved.

The James Heavy Duty Subsoiler is designed to lift and shatter pan layers in the subsoil at a depth of 50cm. This shattering permits the filtering of surface water down through the profile avoiding ponding and allowing moisture to be stored for use during dry periods.

The James Heavy Duty Super Subsoiler is designed to lift and shatter pan layers in the subsoil at a depth of 70cm. This shattering permits the filtering of surface water down through the profile avoiding ponding and allowing moisture to be stored for use during dry periods.

A sliding back chute to lay up to 40mm alkathene pipe. By removing the rear slide, the pipe can be removed from, or inserted into the chute, at any stage, without cutting the pipe and avoiding the need for joiners. All joining of pipes and fittings of tees is completed above ground level.

Transports and stands wrapped round bales on end for storage. Now available in either single or dual units.