- Home
- Equipment
Refine by
Floloc Xprt Equipment & Supplies
7 equipment items found
Manufactured by:Flo Loc Products International based inDana Point, CALIFORNIA (USA)
The POWERPAK provides constant DC operating power for each motorized valve actuator in the system. As the power is used, the batteries are constantly recharged by AC. Standard battery size is 12 Volts DC at 31 Ah, connected in series to provide 24 Volts DC. Should the charging system fail, the fully charged batteries will allow approximately 90 minutes of single valve actuator operation (Consult ...
Manufactured by:Flo Loc Products International based inDana Point, CALIFORNIA (USA)
Manual arm/reset and trip with no SCADA control. This Basic Component provides dry-contacts of the Sensor position only. This unit requires a user provided power source (DCV or ACV). In NEMA 4X Fiberglass enclosure 16X14 (standard - options available). ...
Manufactured by:Flo Loc Products International based inDana Point, CALIFORNIA (USA)
Specifically developed for control valves. Provides simultaneous shutdown of one or more control valves in the event of an earthquake. Standard SCADA and manual arm/reset and trip control and status. Provides a signal to a latching solenoid in the pilot system of the valve In a NEMA 4X Fiberglass enclosure ...
Manufactured by:Flo Loc Products International based inDana Point, CALIFORNIA (USA)
FL201-1, 2, 3, 4, or more - Provides open / closed Panel and SCADA control based solely upon the position of the Seismic Sensor. The valves are fully opened or fully closed by arming or tripping the sensor. FL201-11, 12, 13, 14 or more - Provides Panel and SCADA control to open and close valves and stop at intermediary positions when the Seismic Sensor is Armed. Variations are ...
Manufactured by:Flo Loc Products International based inDana Point, CALIFORNIA (USA)
FLOSAFE Flow Monitoring Safety System, a FLOLOC Patented System, may be added to any FLOLOC Seismic Controller. FLOSAFE only shuts valves when a break in the pipeline is detected in the minutes after a serious seismic event. This eliminates the problem of an unnecessary shutdown. It requires a second signal from a flow meter or other source in the line to initiate a valve shutdown in a seismic ...
Manufactured by:Flo Loc Products International based inDana Point, CALIFORNIA (USA)
If the FLOPAK is in close proximity to the Seismic Controller, then the Power Supply can be combined in the same enclosure allowing for a more streamlined installation. ...
Manufactured by:Flo Loc Products International based inDana Point, CALIFORNIA (USA)
The POWERPAK provides constant DC operating power for each motorized valve actuator in the system. As the power is used, the batteries are constantly recharged by Solar. Standard battery size is 12 Volts DC at 31 Ah, connected in series to provide 24 Volts DC. Should the charging system fail, the fully charged batteries will allow approximately 90 minutes of single valve actuator operation ...