Hydrorock International B.V.
  1. Companies
  2. Hydrorock International B.V.
  3. Services
  4. Gully-Fed Filter Drains Solutions

Gully-Fed Filter Drains Solutions

SHARE

Hydrorock offers a range of natural aquifer block, gully-fed infiltration and attenuation systems for paved or tarmacked areas, for permeable or non-permeable surfaces.

Most popular related searches

Excellent pollution filtration
30 year filter guarantee

Excellent water storage
Double the capacity compared with gravel systems

Streamlined installation
No temporary shoring works, less excavation, fewer lorry trips required

Highway and paving options available
Highly configurable and fully integratible with other Hydrorock systems



  • Roadside and paving options
  • Excellent filtration of pollution
  • 30 year filter guarantee
  • Double the water storage capacity compared with gravel
  • No temporary shoring works required
  • 15% less soil excavation (by volume and weight)
  • 60% less infill weight
  • Far fewer vehicle loads required with Hydrorock
  • 33% bigger infiltration surface area (much more efficient than gravel system)
  • 30 year filter life (double gravel 15 year filter life)
  • Free recycling by Rockwool (gravel needs expensive cleaning)   
  • Full integration with other Hydrorock infiltration or filter drain systems
  • Excellent load bearing up to 40 tonnes and life time system integrity
  • Uniquely high absorption to volume ratio (94%)
  • 100% natural product
  • Recyclable

Installation is very simple and quick with minimal disruption.
Blocks are pre-wrapped with filter membrane, so the excavation needs to be only as large as the system (no access is required to fit the membrane).

  • No specialist installation engineering or equipment is needed, with
    simple snap-together fittings which require no special skills or tools.
  • Hydrorock Blocks are used in a single layer, on a 100 mm layer of sand. This increases the surface area of the bottom of the system.
  • The Hydrorock Blocks are normally installed in a module three blocks wide. This allows for the system to self-vent, and if by human error the filters are compromised, the whole system can be flushed.
  • Hydrorock BD blocks have integrated perforated pipes allowing rapid inflow and storage water in each block underground.
  • Additional capacity can be rapidly and easily achieved by the addition of further Hydrorock BD blocks or Hydrorock B blocks (pre-wrapped but without integrated pipes)
  • The system can be placed around existing infrastructure, such as pipes and cables unlike crated sumps. This flexibility allows for optimisation of the site.
  • Placing the system on a 100mm layer of sand will permit infiltration from the module into the surrounding soil and facilitate the discharge of water from the Hydrorock Aquifer Blocks.