- Home
- Applications
- canada
- solids flow
Refine by
Solids Flow Product Applications Available In Canada
24 applications found
Solids flow and level monitoring refers to any application where solids and/or liquids need to be measured to record flow rate or detect potential blockages. PulsarGuard acoustically detects solids and clogs in the vacuum ...
ByPulsar Measurement based in Birmingham, UNITED KINGDOM
Silo level and solid flow indication can become quite tricky, especially when things like high dust levels interfere with the atmospheric conditions of a process. mmWAVE Radar can give continuous level monitoring in silos, without being compromised by these factors. Pulsar guard can give an indication of the change in flow rate of solids though ducting/conveyors to indicate that something within the process has changed. ...
ByPulsar Measurement based in Birmingham, UNITED KINGDOM
Fracking is another method used to extract oil and gas, using the process of injecting high pressure into subterranean rocks and boreholes so as to force open existing fissures and extract the oil or gas. Pulsar Measurement provide many different flow and level solutions to this market, from flow monitoring, to level monitoring, pump control and sand in oil detection. There is plenty of choice within our portfolio for a measurement solution perfectly suited to your ...
ByPulsar Measurement based in Birmingham, UNITED KINGDOM
Plugged chute or blocked chute detection...If properly implemented, a level sensor / switch or solids flow monitor can indicate a condition consistent with a flow stoppage within a chute, hopper or conveying line. ...
ByMonitor Technologies, LLC based in Elburn, ILLINOIS (USA)
Premium
In addition to main stack emission monitoring and measurement, by closely monitoring process conditions such as solids flow, the measurement of material mass via non-intrusive, solid state powder mass measuring systems and proactive baghouse performance monitoring can improve process ...
ByENVEA based in Poissy, FRANCE
Accurate measurement of solid and liquid flow is vital to any farm, and enables the farm to have accurate stock level management, provides easier and simpler asset management, helps to plan predictive maintenance, alerts staff of high/low levels, when spillages occur and aids with compliance. Pulsar Measurement offer a wide range of technologies including acoustic technology that listens to the flow within a pipe, warning staff of any blockages/issues within the ...
ByPulsar Measurement based in Birmingham, UNITED KINGDOM
A coal-fired power plant in India, Hidalco Industries, needed a sure-fire way to detect the flow or no-flow of coal from the feeders to the furnaces. A plugged chute or equipment failure would possibly go unnoticed until a more serious problem occurred. Knowing whether the coal was positively feeding into the furnaces was of paramount importance to the efficient operation of the power plant. How can a coal-fired power plant economically and reliably determine if coal feed is flowing when needed? ...
ByMonitor Technologies, LLC based in Elburn, ILLINOIS (USA)
Industries including automotive, aerospace and electronics utilize processes that include metal finishing and metal working to produce or plate products and components. These processes, such as electroplating, can often result in wastewater contaminated with heavy metals that require treatment prior to recycling or discharge. Porex Tubular Membrane Filters (TMF™) provide the best option for many recycling or discharge treatment systems. The Porex membranes combine extremely rugged, durable construction for ...
ByPorex - Filtration Group based in Fairburn, GEORGIA (US) (USA)
Industrial wastewater applications including metals finishing, semiconductor processes and fluoride reduction utilize cross flow filtration systems to provide optimal flux and prolonged filter functionality. Porex’s cross flow membranes, specifically microfiltration and ultrafiltration membranes, work to create an optimal cross flow filtration system that’s long lasting and easy to service. Our cross flow membrane systems are ideal for processing industrial wastewater due to the higher overall ...
ByPorex - Filtration Group based in Fairburn, GEORGIA (US) (USA)
High fluoride levels in wastewater can be problematic for industries using hydrofluoric acid (HF) as a cleaning agent or etchant, such as the semiconductor, solar cell and metals manufacturing industries. HF is also used as a reactant or catalyst in the plastics, pharmaceutical, petroleum refining and refrigeration industries. Fluoride concentrations from these industries may range from 100 to more than 10,000 ppm in rinse waters, but discharge limits are often below 20 ppm. ...
ByPorex - Filtration Group based in Fairburn, GEORGIA (US) (USA)
RO Reclaim/Zero Liquid Discharge (ZLD) with Lime Softening for Industrial Processes including Power Plants, Mining Industry, Steel Industry. Typical recycling, reuse and process water systems use Reverse Osmosis (RO) technology as the method of decreasing the level of ions in process water. RO recovery rates normally range from 50-75%, therefore 25-50% of the RO feed water is discharged as wastewater. With the increasing cost of water and waste discharge, more companies are looking to recover and reuse RO reject ...
ByPorex - Filtration Group based in Fairburn, GEORGIA (US) (USA)
The semiconductor, microelectronics, solar cell and solar panel manufacturing industries use large volumes of process and ultrapure water. The processes using this expensive water often leave contaminants that can be very difficult to remove using conventional water treatment. These include die sawing and backgrinding grit, dissolved metals, fluoride and other ...
ByPorex - Filtration Group based in Fairburn, GEORGIA (US) (USA)
High Solids Filtration - SDI/Solids Reduction: The two (2) main technologies used to reduce suspended solids are clarification and media filtration. Clarifiers require a high level of monitoring and supervision to prevent the passing of large slugs of solids due to temperature and chemistry upsets. In addition, the organic polymers used in clarifiers (to promote flocculation), can also cause problems. An excess of these polymers will foul downstream filtration equipment such as RO membranes or nanofilters. Since ...
ByPorex - Filtration Group based in Fairburn, GEORGIA (US) (USA)
With the increasing need for recycling industrial waste water – either because of limited water resources or because of stricter waste water discharge regulations – many industrial producers are considering implementation of zero liquid discharge (ZLD) filtration systems. A ZLD system contains several processes that together separate unwanted substances from the waste water to produce high quality water for reuse. ZLD processes virtually eliminate all waste water discharge. ...
ByPorex - Filtration Group based in Fairburn, GEORGIA (US) (USA)
Emulsified oil in wastewater can be problematic for industries wanting to discharge or recycle it, such as the automotive, aerospace, textile and plastics industries. Oil concentrations from these industries may range from 1,000 to more than 100,000ppm in wastewaters, but discharge limits are often below 100ppm. Today, recycle and reuse are needed for any viable water source. To reuse or recycle wastewater, oil levels of less than 30ppm are required. ...
ByPorex - Filtration Group based in Fairburn, GEORGIA (US) (USA)
Tanks used in this field are typically referred to as ‘frac’ tanks, the 500 barrel Frac Master being the industry benchmark. ‘Frac’ is an abbreviation for fractionation, a term that refers to an actions which occur when bringing a new well online or reworking an existing well to stimulate existing ...
ByPinnacle Manufacturing based in Boaz, ALABAMA (USA)
Process Information: Most Air Scrubbers treating gas emissions to atmosphere in Phosphoric Fertiliser plants (MAP, DAP, NPK etc) have a Chevron Vane type or a mesh type droplet separator on the exit to catch liquid droplets. These Chevron Vanes and mesh pads can block, and need replacing from time to ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
Slurry transportation is required in a diverse range of sectors, from food to minerals processing; and oil sands processing to nuclear waste management. As a process it requires significant levels of energy and the abrasive nature of materials used can lead to ongoing issues of pipeline ...
ByIndustrial Tomography Systems Ltd. (ITS) based in Manchester, UNITED KINGDOM
Premium
From the measurement and control of emitted dust from dryer filter plant to the non-intrusive, solid state measurement of powder mass flow and the monitoring of process gas quality, ENVEA instrumentation provides Plant Operators with the opportunity to fine tune their manufacturing process to drive down costs, improve quality and reduce unplanned plant outages. ...
ByENVEA based in Poissy, FRANCE
Countercurrent Decantation (CCD): Rock passes into a dump hopper and is then transferred to a vibrating grizzly screen. The oversized material is sent to a jaw crusher. The crushed product is combined with the grizzly undersize and the ore is conveyed to the coarse ore bin. ...
ByWesTech Engineering, LLC based in Salt Lake City, UTAH (USA)