Refine by
Industries served
- Water and Wastewater
- Manufacturing, Other
- Mining
- Oil, Gas & Refineries
- Soil and Groundwater
- Chemical & Pharmaceuticals
- Agriculture
- Monitoring and Testing
- Food and Beverage
- Energy
- Electronics and Computers
- Pulp & Paper
- Environmental
- Air and Climate
- Forestry & Wood
- Glassware
- Commercial
- Medical / Health Care
- Waste and Recycling
- Maritime/Shipbuild/Water Transport
- University / Academia / Research
Xprt Product Applications In Algeria
162 applications found
Premium
OPSIS EEx Zone 1 and 2 certified monitoring equipment meets the demands for monitoring in harsh areas with a high amount of corrosive gaseous compounds. OPSIS offers two monitoring solutions, TDL (Tuneable Laser Diode) technology with ER060L-EEx emitter and receiver set, for harsh installations, and OPSIS O2000 oxygen monitor. The most suitable technique is used for the application at ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
OPSIS is a world-leading supplier of gas monitoring systems for various special applications in the process control sector. The OPSIS process monitoring systems have been tested and approved by a range of international authorities, and has proven to have the best performance and longest calibration intervals. We specialise in the design and supply of high accuracy, low maintenance, cross-duct, non-extractive process control systems. We also provide additional products and services, including dust and flow ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
There can be several purposes for monitoring the air quality in an urban area. If the aim is to assess what the residents are exposed to in the worst case, a so-called street-level monitoring is carried out. If the aim is to monitor the general levels of air pollution and follow up long-term trends, you should instead monitor further away from the busiest roads, for example at roof level. ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Monitoring the air quality at and around airports can be done for several reasons. It may be a question of monitoring the pollutants that employees and passengers are exposed to, but it may also be a matter of studying the contribution of aviation and ground traffic to pollution. Regardless of purpose, monitoring can be a challenge. The location of the measurement site must be representative. A large number of gaseous components need to be monitored with high accuracy and high ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
OPSIS non-contact monitoring solutions, based on either DOAS or TDL techniques, are very well suited for applications in the mining and smelting Industries, as the flue gas conditions often involve high temperatures and high dust ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
OPSIS offers monitoring systems for continuous emissions monitoring and process control at power plants. The systems meet and exceed high demands on availability, speed, versatility, and low operating ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Monitoring in raw gas places high demands on the instruments. The temperatures are high and the gases are often reactive. There may also be high dust levels. In order to control flue gas cleaning, the monitoring systems must also be able to react in near real time. However, these are no problems for OPSIS non-contact monitoring systems, which work excellently in these circumstances, with high availability and low operating ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Benzene monitoring around refineries: Measuring benzene emissions from a refinery plant can be challenging, but OPSIS makes it easy. Benzene is a liquid hydrocarbon that evaporates rapidly when exposed to ambient air. It is one of the more common substances used in the chemical industry and is particularly prevalent at refineries and similar operations. Benzene causes cancer and is therefore subject to ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
OPSIS is a world-leading supplier of CEMS (continuous emissions monitoring systems) for various special applications in the industrial emissions sector. The OPSIS gas monitoring systems have been tested and approved by a range of international authorities, and has proven to have the best performance and longest calibration intervals. We specialise in the design and supply of high accuracy, low maintenance, cross-duct, non-extractive CEM systems. We also provide additional products and services, including dust and ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
In recent years, increasingly strict requirements have been introduced to minimise sulfur emissions from shipping. One way to comply is to run the ships with low-sulfur oil, but this can be expensive. An alternative that makes it possible to continue using high-sulfur oil as fuel is to install SO2 scrubbers that clean the flue gases to the same level as if the ships were fueled with low-sulfur oil. However, the scrubbers must be monitored by measuring the ratio of SO2 to CO2 concentrations. Here, OPSIS has a ...
ByOPSIS AB based in  Furulund, SWEDEN
Measure porosity and estimate permeability in saturated materials without the risk inherent in radioactive sources or the data gaps and expense of packer testing. Improve site investigation and clarify ...
ByVista Clara, Inc based in  Mukilteo, WASHINGTON (USA)
Measure moisture content in tailings, earthen dams, heap leach piles, and waste rock. Determine pore size distribution and identify perched ...
ByVista Clara, Inc based in  Mukilteo, WASHINGTON (USA)
The supply and distribution of precious water resources is rapidly becoming among the world’s most high-value — and high-risk — products and services. Avoiding water leaks and failures caused by corrosion or high-pressure burst incidents in pipes, tanks, and water-distribution infrastructure has become a top priority for today’s water utilities and municipalities managing water resources. ...
ByMobiltex Data Ltd. based in  Calgary, ALBERTA (CANADA)
AGC Instruments provide the complete analytical solutions to analyse impurities in many Matrix Gases. With a wide range of successful installations world wide, we can design a system that will meet your exact needs and guarantee top class ...
ByAGC Instruments Ltd. based in  Shannon, IRELAND
Turn-key feed fills and plants for compound feed, shrimp and fish feed, pet food, premix / concentrate, and ...
ByAmandus Kahl GmbH & Co. KG based in  Reinbek, GERMANY
Possible applications of the KAHL pelleting press: Wood waste, wood shavings, wood chips, sawdust, wood and grinding dust, straw, miscanthus, bagasse and other ...
ByAmandus Kahl GmbH & Co. KG based in  Reinbek, GERMANY
Nowadays, the pelleting and granulation process is used in various production branches of the chemical and pharmaceutical ...
ByAmandus Kahl GmbH & Co. KG based in  Reinbek, GERMANY
We know the different needs of butadiene, ammonia, fertilizer producers and other chemicals manufacturers. Leveraging years of industry and region-specific experience, SUEZ experts work in lockstep with your team to tailor the right solution to meet your operational ...
BySUEZ Water Technologies and Solutions based in  Trevose, PENNSYLVANIA (USA)
Man-portable NMR Geophysical Instruments for Soil, Sediment and Core Measurements. Vista Clara’s family of man-portable NMR tools enable direct measurement of volumetric water content and high-resolution pore-scale analysis of soils, sediments and core samples. These tools are all man-portable and designed for use in the ...
ByVista Clara, Inc based in  Mukilteo, WASHINGTON (USA)
Fault zones: Geological faults are related to an increase in weathering and loosening up of the surrounding rock, which causes an increase in hydraulic routing. This lowers the rigidity of the rock and increases the risk for constructing new buildings. In the event of an earthquake, even dislocations are possible along the fault. Seismic refraction measurements enable the mapping of seismic velocities and related material properties. The lateral variations of these velocities then indicate the location of fault ...
ByGeotomographie GmbH based in  Neuwied, GERMANY