asia middle east
Applications

Xprt Product Applications In Asia Middle East

6,475 applications found

In Asia & Middle East Available In Asia & Middle East Near Asia & Middle East

Solutions for Industries and Plastic Part Applications

Industry context changes the questions a mold maker and molder must ask, but it does not replace part-level engineering. CKMOLD supports molded components across medical and diagnostic, automotive, electronics, industrial equipment, appliance and consumer programs where the customer defines product requirements and approval ...

ByC.K.Mold & Engineering Limited based in Shenzhen, CHINA

Regenerative Thermal Oxidizer

A regenerative thermal oxidizer (RTO) is a piece of industrial equipment used for the treatment of exhaust air. The system is a type of thermal oxidizer that uses a bed of ceramic material to absorb heat from the exhaust gas. It then uses this captured ...

ByPingxiang Annareach Technology Co., Ltd. based in Kowloon, HONG KONG

Volatile Organic Compounds (VOC)

VOC emissions are currently issued into the atmosphere in a large number of production processes that use organic substances in several industries, such as Chemical, Pharmaceutical, Petrochemical, Automotive, Flexoprinting, Oil & Gas, etc. Current EU and ...

ByPingxiang Annareach Technology Co., Ltd. based in Kowloon, HONG KONG

Usage considerations for RTO blocks

• Try to put the blocks in order when you install the blocks; • Keep expansion gap every 1 centimeter per 1meter evenly distributed when place the blocks; • The speed of temperature rise and fall should not be too fast, otherwise it ...

ByPingxiang Annareach Technology Co., Ltd. based in Kowloon, HONG KONG

Our New blocks-Hexagonal holes blocks

#Advantage 1. Compared with square holes, the hexagonal hole structure have following advantage -- the hole has six 120 angle, smaller curvature of the corners, larger exchange area, lower 14% pressure drop, higher heat exchange efficiency, can be ...

ByPingxiang Annareach Technology Co., Ltd. based in Kowloon, HONG KONG

Intelligent compliance solutions for electronics and medical devices

Few industries face the mounting challenges and scrutiny of expanding environmental compliance requirements, ecological mandates, consumer expectations and NGO watch groups as much as electronics and medical device manufacturers. Even before the Sony PlayStation cadmium crisis, the entire supply chain has been inundated by an ever-expanding myriad of legislation, ranging from the EU Directives on waste electrical and electronic equipment (WEEE), the restriction of hazardous substances (RoHS) and the Registration, ...

By3E - SDS and EHS Compliance Data Management Solutions based in Carlsbad, CALIFORNIA (USA)

Water monitoring instruments for chemicals & petrochemicals

We understand that keeping your supply chain efficient is key to improving productivity and reducing your unnecessary ...

ByOvarro based in Eckington, UNITED KINGDOM

Surface preparation

Problem: Removing rust, scale and coatings with grit blasting requires containment and/or clean-up, and those costs can have a significant impact on profitability. For contractors doing environmental remediation – removing asbestos or lead paint, for example – the containment issue is even more ...

ByNLB Corporation based in Wixom, MICHIGAN (USA)

Measurement solution for Perflurocarbon (PFC) emissions from aluminium industry

The aluminium industry is the major source of perflurocarbon (PFC) emissions to the atmosphere, which are a major contributor to global warming. PFCs have greenhouse gas effects up to 10000 times that of CO2. Emissions have been reduced over the last 20 years, but further reductions are harder to achieve as all the mechanisms for PFC production are not known. In order to better understand the production of PFC on an industrial level, laboratory studies have been carried out using a small scale ...

ByProtea Limited based in Middlewich, UNITED KINGDOM

Desalination Thermal Multi Stage Flash Technology (MSF)

Aquatech MSF ( Multi Stage Flash) Desalination technology was developed more than fifty years ago, and were some of the first to install large size MSF equipment plants in Saudi Arabia, a key market in desalination. With our depth of technological expertise and experience in operating plants, we are positioned to offer the best support in design optimization and rehabilitation of existing facilities. Uses low pressure steam as heat source Highly reliable, and simple to operate & maintain ...

ByAquatech International Corporation based in Canonsburg, PENNSYLVANIA (USA)

Desalination Thermal Multiple Effect Distillation (MED)

Aquatech’s Multiple Effect Distillation (MED) Desalination technology, using a spray film™ design, has been developed and improved over decades of in- house research and onsite experience of such systems worldwide to provide an environmentally friendly system to meet the global challenges of a reduced carbon footprint. Production capacity up to 10 MIGD (45,500 m3/day) in a single unit: Significantly lowers electrical consumption Design flexibility to use low to medium pressure supply steam Minimum down ...

ByAquatech International Corporation based in Canonsburg, PENNSYLVANIA (USA)

Industrial solutions for cooling water contamination

Problem: Large quantities of water are used for cooling in industrial manufacturing. To prevent scaling, corrosion and biofilm in the cooling system, inhibitors and biocides are regularity dosed. Make-up water is continuously added to the system to balance the loss of water from evaporation. As water is added, the concentration of chemicals is diluted and the quality of water ...

ByUviTec, part of ABB (Formerly Real Tech Inc.) based in Whitby, ONTARIO (CANADA)

Hydrocyclones for quench water treatment

Cost Effective Protection with KREBSs Hydrocyclones for Quench Water Treatment. High Efficiency products to remove mill scale in steel plants and metal forming ...

ByFLSmidth A/S based in Valby, DENMARK

Ultraviolet disinfection systems for the flowback water treatment - shale gas

Natural oil and gas extracted from shale rock formations has become one of the fastest-growing oil and gas sectors worldwide. Using a process known as hydraulic fracturing or 'fracking' , the process requires large volumes of clean, sterile water to be injected into the shale formation to release the gas trapped between the ...

Byatg UV Systems - a brand by EVOQUA Water Technologies LLC based in Wigan, UNITED KINGDOM

Hose and tube pumps for Pharmaceuticals & laboratory industry

Chemical resistant dosing pumps; Verderflex tube pumps provide precision pumping and dispensing solutions for the pharmaceutical industry. The pumps range from being manually operated to versatile units with sophisticated dosing programs. Capable of speed, accuracy and the easy to use pump range are perfect for dispensing delicate, viscous, corrosive, shear sensitive or abrasive fluids. Dispensing flows from a few ml/min up to 17 l/min* Dosing accuracy of ...

ByVerder Liquids BV - part of the Verder Group based in Vleuten, NETHERLANDS

iTAC.MOM.Suite for Cable & Wire Processing

Companies in the cable processing industry are facing growing challenges in terms of quality and efficiency of their production as the complexity of the products increases. A smart IT solution can help companies to keep up with the fast-paced development in the industry and even more, it helps in optimizing existing processes and related ...

ByiTAC Software AG based in Montabaur, GERMANY

Water treatment solutions for hospitals industry

A huge percentage of populations worldwide are affected by infections acquired from hospitals. Infections generated from hospitals are a major challenge to public healthcare systems. In order to avoid the risk of infections it is necessary to ensure the hospitals are properly disinfected and sanitized. The most common methods of sanitizing is with the use of disinfectant solutions. Contaminated surfaces are sources of infections and require care of high level of compliance with recommended hand hygiene policies ...

ByPristine Water based in , INDIA

Water treatment solutions for hotels and resorts industry

All Hotels and resorts use water everywhere like bathing, laundry, cooking, drinking, cooling, swimming pools, fire water etc. Main concern of providing and storing water is to keep them pure free from contamination and prevent the growth of algae and ...

ByPristine Water based in , INDIA

Ter Polymer

Properties: Ter Polymer is copolymer of carboxylic group, hydroxylic group and sulfonic acid group, it has good scale inhibition performance to calcium phosphate and calcium carbonate. Ter Polymer has good synergic effects with other agents. Ter Polymer ...

ByZEEL PRODUCT based in Vadodara, INDIA

DTPMP

Properties: DTPMPA is innocuous, easy to be dissolved in acid solution. DTPMPA has excellent scale and corrosion inhibition and good thermal tolerance ability. DTPMP, ...

ByZEEL PRODUCT based in Vadodara, INDIA

Need help finding the right suppliers?Try XPRT Sourcing. Let the XPRTs do the work for you