- Home
- Applications
- australia
- process gas stream
Show results for
Refine by
Process Gas Stream Product Applications In Australia
13 applications found
Natural gas gathering systems deliver large volumes of gas via pipleline to the central inlet of the gas processing facility. Removal of solid contaminants and free liquids present in the inlet gas is critical to the downstream process. Iron oxides, iron sulfides, dirt and other deformable particles can flow into the processing system. Effective removal of these contaminants is needed to prevent fouling. Pentair Porous Media technologies will help with a clean, natural gas feed, reducing upsets and associated ...
ByPentair Filtration Solutions, LLC based in Conroe, TEXAS (USA)
Fuel Gas Streams are frequently contaminated with liquid aerosols. The liquid exists as a stable and persistent “smoke” in the gas stream. The liquid contaminant can enter the gas stream through any one of a variety of events including – phase separation and condensation, compressor lube-oils from compression, chemical addition to pipelines (including corrosion inhibitors), and entrainment from overheads of contact ...
ByPentair Filtration Solutions, LLC based in Conroe, TEXAS (USA)
Widely diversified grouping of process chemicals and additives spanning functional fluids, antioxidants, catalysts, pesticides, biocides, adhesives and sealants, corrosion inhibitors, flame retardants, synthetic dyes, specialty pigments, etc. Precoat filter upgrade, increase productivity, capacity and fluid ...
ByPentair Filtration Solutions, LLC based in Conroe, TEXAS (USA)
Reactor products can contain gelatinous, deformable solids form in coating formulation. Batch Process: Limited reactor turn-over (constrained through-put) due to long filtration process. Reduce operating costs and batch cycle time, double capacity and increase online ...
ByPentair Filtration Solutions, LLC based in Conroe, TEXAS (USA)
The key to optimizing a hydroprocessing unit is to maximize the life of the catalyst bed and increase energy efficiency of the furnaces. Our goal is to eliminate fouling of the catalyst bed by particles and aqueous fluids and the dissolved components within them as well as fouling of hydrogen recovery membranes and furnace-burner ...
ByPentair Filtration Solutions, LLC based in Conroe, TEXAS (USA)
Purify benzene, toluene, and xylene (BTX) from refinery or petrochemical aromatics streams such as catalytic reformate or pyrolysis gasoline. This liquid-liquid extraction processes offers lower capital and operating costs, simplicity of operation, range of feedstock, and solvent ...
ByPentair Filtration Solutions, LLC based in Conroe, TEXAS (USA)
Glycol dehydration is a liquid desiccant system for the removal of water from natural gas and natural gas liquids (NGL). It is the most common and economic means of water removal from these streams.Glycols typically seen in industry include triethylene glycol (TEG), diethylene glycol (DEG), ethylene glycol (MEG), and tetraethylene glycol (TREG). TEG is the most commonly used glycol in ...
ByPentair Filtration Solutions, LLC based in Conroe, TEXAS (USA)
The key aspects of a caustic treating system pertain to the degree of contact between the caustic and hydrocarbon to facilitate the mass transfer. Increasing the specific surface area of contact in a two phase system necessarily creates a tight emulsion. The product hydrocarbon often contains entrained caustic, which is not easily recovered by a simple water wash followed by a separator drum. The spent caustic is often regenerated with sour-naphtha stream that is used to extract the disulfide oils into the ...
ByPentair Filtration Solutions, LLC based in Conroe, TEXAS (USA)
Silicones are inert, synthetic compounds with a variety of forms and uses. Typically heat-resistant and rubber-like, they are used in sealants, adhesives, lubricants, medical applications, cookware, and insulation. Silicones are polymers that include silicon together with carbon, hydrogen, oxygen, and sometimes other chemical elements. Some common forms include silicone oil, silicone grease, silicone rubber, and silicone ...
ByPentair Filtration Solutions, LLC based in Conroe, TEXAS (USA)
There are a number of factors that affect the capacity and operation of a typical amine system. Solid or liquid contaminants in the system may cause foaming. The presence of foaming is typically addressed by the addition of expensive antifoam chemicals and/or by reducing the operating capacity of the amine system. In addition to this, the presence of contaminants in the system can foul heat exchangers and column packing or trays. These solid and liquid contaminants are either ingressed into the system with the ...
ByPentair Filtration Solutions, LLC based in Conroe, TEXAS (USA)
Application: Anaerobic Digestion plants produce various gas components from a source material (or feedstock) that can be composed either solely or as a mixture of slurries, purpose-grown crops, food and organic waste material. The composition of the gas produced varies depending upon the feedstock and the Anaerobic digestion process itself. As a consequence, it is normal to measure various components of the resultant gas produced to evaluate the efficiency of the Anaerobic Digestion process. Furthermore, due to ...
ByEdinburgh Sensors Ltd - TECHCOMP Group based in Livingston, UNITED KINGDOM
The key aspects of an alkylation unit pertain to the amount of acid that needs to be made-up on a continuing ...
ByPentair Filtration Solutions, LLC based in Conroe, TEXAS (USA)
Air and Gas Treatment: the Challenge Treatment of air and process gases typically has two fundamental drivers: regulatory compliance and/or product purity. Many industrial operations face increasingly stringent discharge limits on volatile organic compounds (VOCs). From a process purity standpoint, many process gases contain undesired impurities that can be removed with Jacobi’s EcoSorb and AddSorb products. ...
ByJacobi Group based in Kalmar, SWEDEN