Show results for
Refine by
Industries served
- Air and Climate
- Monitoring and Testing
- Metal
- Pulp & Paper
- Mining
- Glassware
- Chemical & Pharmaceuticals
- Oil, Gas & Refineries
- Water and Wastewater
- Energy
- Automobile & Ground Transport
- Waste and Recycling
- Maritime/Shipbuild/Water Transport
- Agriculture
- Environmental
- Health and Safety
- Manufacturing, Other
- Food and Beverage
So2 Product Applications In Canada
69 applications found
Premium
The measurement of pollutants such as O3, NO, NO2, CO, SO2 and HC to ppb’s and ppm’s require very sensitive analysers. ...
ByLNI Swissgas based in Versoix, SWITZERLAND
Pyrometallurgical extraction of metals from sulphur containing ores generate large amounts of SO2 and particulate emissions. Macrotek has designed integrated systems to capture particulate and neutralizes ...
ByMacrotek Inc. based in Markham, ONTARIO (CANADA)
SO2 (sulfur dioxide) is measured in a number of applications. SO2 is used as a food grade preservative and must be regulated in accordance with government-set criteria to be safe for consumers. ...
ByUnisearch Associates Inc. based in Concord, ONTARIO (CANADA)
Premium
Process monitoring at a sulfuric acid plant requires good and reliable detection of, among other things, sulfur dioxide (SO2) in gas phase. This can be a challenge due to high concentrations of SO2, high temperatures, and high pressure. Monitoring may be needed at several locations in the process where SO2 concentrations may vary from a few mg/m3 to several percent by volume. ...
ByOPSIS AB based in Furulund, SWEDEN
ByAMETEK Process Instruments based in Pittsburgh, PENNSYLVANIA (USA)
Premium
An alternative that makes it possible to continue using high-sulfur oil as fuel is to install SO2 scrubbers that clean the flue gases to the same level as if the ships were fueled with low-sulfur oil. However, the scrubbers must be monitored by measuring the ratio of SO2 to CO2 concentrations. Here, OPSIS has a certified, cost-effective, and reliable ...
ByOPSIS AB based in Furulund, SWEDEN
Premium
Among other things, nitrogen oxides (NOX) and sulfur (sulfur dioxide, SO2) are regulated. OPSIS has the instruments to monitor the ...
ByOPSIS AB based in Furulund, SWEDEN
Premium
In the case of emissions from ships, it may be of particular interest to monitor sulfur dioxide (SO2) levels near the stacks to confirm that low-sulfur oil is being used or that desulfurisation is activated. ...
ByOPSIS AB based in Furulund, SWEDEN
Production of aluminum from its ores at aluminum smelters results in carbon dioxide CO2, carbon monoxide CO, sulfur dioxide SO2, and hydrogen fluoride HF gas emissions to the atmosphere. Read about our solutions for aluminum ...
ByGasmet Technologies - a Nederman company based in Vantaa, FINLAND
Dürr provides custom-designed gas cleaning solutions for the metallurgical industry: wet electrostatic precipitators for collecting fine particulate and sulfuric acid mists from SO2-rich gas streams, acid gas control with wet absorbers, and control of high-temperature furnace and converter ...
ByDürr Systems, Inc. based in De Pere, WISCONSIN (USA)
Premium
These instruments automatically perform zero, precision, span and multi-point calibrations using NO, NO2, SO2, CO, O3, hydrocarbons and other gases of interest. All ozone generators are factory calibrated using a NIST traceable ozone standard. ...
ByEnvironics, Inc. based in Tolland, CONNECTICUT (USA)
Flue Gas Desulfurization (FGD) involves the removal of sulfur dioxide and other acids from flue gases. Typical sources of acid gases include fossil fuel boilers, waste combustors, and other industrial applications such as refining and smelting. The Macrotek wet and dry FGD systems can achieve over 99% acid removal by using a variety of reagents, including caustic, sodium carbonate, lime and limestone, and waste alkaline solids or liquids. ...
ByMacrotek Inc. based in Markham, ONTARIO (CANADA)
Premium
Method allows determination of mass concentration of total sulfur dioxide (sulfurous acid and its salts, food additives E220–E228) in wine, wine materials, beer and beer products by capillary electrophoresis (CE) using capillary electrophoresis system “CAPEL® -105M”. The mass concentration of total sulfur dioxide is regulated by normative documents to be held within 100– 400 mg/L for different types of wine and wine materials and within 20–50 mg/L for beer products. According to ...
ByLumex Instruments based in Mission, BRITISH COLUMBIA (CANADA)
Typical applications include live on-board exhaust monitoring (CO, CO2, N2O, NOx, formaldehyde, acetaldehyde, oxygen and moisture), analysis of raw and dilute exhaust gas from the engine and tailpipe with gas-bags (CO2, N2O, NOx, CH4, EtOH, THC, H2S, SO2, NH3, formaldehyde and acetaldehyde), diesel Selective Catalytic Reduction (SCR) after-treatment monitoring (NH3) and the Sealed Housing for Evaporative Determination ...
ByGasera Ltd based in Turku, FINLAND
Premium
OPSIS non-contact monitoring solutions, based on either DOAS or TDL techniques, are very well suited for applications in the mining and smelting Industries, as the flue gas conditions often involve high temperatures and high dust ...
ByOPSIS AB based in Furulund, SWEDEN
Premium
Monitoring the air quality at and around airports can be done for several reasons. It may be a question of monitoring the pollutants that employees and passengers are exposed to, but it may also be a matter of studying the contribution of aviation and ground traffic to pollution. Regardless of purpose, monitoring can be a challenge. The location of the measurement site must be representative. A large number of gaseous components need to be monitored with high accuracy and high ...
ByOPSIS AB based in Furulund, SWEDEN
Premium
Various types of sulfur compounds often arise during the production of paper pulp. There are emission limits and monitoring requirements, often expressed as total reduced sulfur, TRS. TRS includes hydrogen sulfide, H2S, and the sulfur compounds methyl mercaptan, dimethyl sulfide, and dimethyl disulfide. OPSIS offers systems to monitor both H2S and ...
ByOPSIS AB based in Furulund, SWEDEN
Pulp and paper production with none of the odor. Pulp and paper manufacturing is a notorious source of nuisance odors, often stemming from hydrogen sulfide, mercaptans and sulfur dioxide. Fortunately, Ecosorb products offer a natural and effective solution to neutralize these odors and all others associated with the paper and pulp industry. Ecosorb odor eliminators have been used repeatedly by large paper and pulp manufacturers to control odors around on-site black liquor lagoons, primary clarification ponds and ...
ByEcosorb by OMI Industries based in Palatine, ILLINOIS (USA)
Titan Hydroxyl Systems are specially designed for custom solutions in the most contaminated industrial areas found. Titan Hydroxyl systems produce high volumes of hydroxyl radicals and super Hydro Peroxides while no harmful by products or materials that would otherwise require disposal or treatment. Hydroxyl Generators do not require contaminated absorption media or filters as well as zero chemicals to deodorize. Hydroxyl radicals are 100% safe for occupied areas containing humans, animals and plants. Unlike ...
ByInternational Ozone Technologies Group, Inc. (IOTG) based in Delray Beach, FLORIDA (USA)
Premium
Process monitoring and monitoring of emissions from aluminium smelters can be a challenge due to high concentrations of for example hydrogen fluoride (HF) and dust. The use of sampling systems in such environments requires a lot of maintenance and is therefore costly. Such systems can also be unreliable. OPSIS offers better ...
ByOPSIS AB based in Furulund, SWEDEN