Refine by
Industries served
- Monitoring and Testing
- Water and Wastewater
- Manufacturing, Other
- Air and Climate
- Energy
- Oil, Gas & Refineries
- Environmental
- Mining
- Construction & Construction Materials
- Agriculture
- Food and Beverage
- Chemical & Pharmaceuticals
- Medical / Health Care
- Metal
- Pulp & Paper
- Waste and Recycling
- Glassware
- Automobile & Ground Transport
- Electronics and Computers
- University / Academia / Research
- Packaging
- Health and Safety
- Soil and Groundwater
- Defense
- Plastics & Resins
- Aerospace & Air Transport
- Maritime/Shipbuild/Water Transport
- Forestry & Wood
- Paint
- Printing
- Communications / Telecom / Datacom
- Commercial
- Government
- Logistics
- Textile
- Travel & Leisure
- Domestic
- Retail
Xprt Product Applications In Finland
1,338 applications found
CO2 is one way to control pH. In raw water if pH is low, then the reason is usually dissolved CO 2 . This can be removed with UGOx that can remove CO2 in pressurized pipeline. The good thing is that no chemicals are not needed as dissolving of air strips the gases out from water. If pH is too high, dissolving CO 2 through OxTube makes the pH lower naturally. This takes place is second or fracture of ...
BySansox Oy based in  Lahti, FINLAND
Both ground and surface water usually contain unwanted gases that should be removed before usage. UGOx is the answer to this problem. UGOx consists of OxTube, compressed air and GasRemox can remove unwanted gases like CO 2 and others gases that have been dissolved into the raw water. This way no bigger tanks or pools are not needed as UGOx can remove all the gases in pressurized pipeline and this saves energy as no extra pumping is ...
BySansox Oy based in  Lahti, FINLAND
Manganese removal takes place often at the same time as iron removal. In manganese pH value plays more important role. The setup is the same as in iron removal. The solution consists of OxTube, possibly GasRemox and sand filters. This solution can be installed into separate container or inside of the pump house. Both systems can be installed also afterwards to the water system. ...
BySansox Oy based in  Lahti, FINLAND
ByBMH Technology Oy based in  Rauma, FINLAND
In landfills, tyres do not decompose for hundreds of years, occupy a lot of space and also represent a substantial fire risk. Using tyres as a fuel is promising, but transport to incinerators may be too costly. For all these reasons, tyres are often shredded prior to dumping or incineration or for re-use as rubber crumb. Rubber crumb is increasingly applied in roadbuilding -rubber asphalt or ‘whispering’ asphalt - or as a resilient base for running tracks, tennis ...
ByCastolin Eutectic GmbH based in  Kriftel, GERMANY
The United States Environmental Protection Agency (EPA) has two stack testing methods for FTIR gas analyzers. Method 320 is an FTIR method for measuring wide range of organic and inorganic pollutants. Method 321 is a specific version for measuring hydrogen chloride HCl at cement kilns producing Portland cement. These methods define a quality assurance and control processes for verifying the accuracy of the results. The requirements for analytical equipment and software are defined on 40 CFR Part 60 Appendix B ...
ByGasmet Technologies - a Nederman company based in  Vantaa, FINLAND
Whether you are in the city, suburb or at a weekend getaway location, noise is an important factor in determining your quality of life or the success of your business. Many areas have local noise legislation that defines the noise limits that can be produced and experienced during the day or at night. This noise may be generated by vehicle traffic, aircraft, industrial sites, construction projects, entertainment events, or many other ...
ByLarson Davis, a division of PCB Piezotronics based in  Depew, NEW YORK (USA)
Every day, unhealthy air quality affects lives of millions of people all over the world. Numerous studies have shown correlation between particle concentration and adverse health effects especially for sensitive groups of people. Whereas regulated fine particle concentration values in air often focus only on PM10 and PM2.5, a more detailed determination of particle characteristics if often needed to fully understand the link between PM and their effect on human health. To determine the source of the particles in ...
ByDekati Ltd. based in  Kangasala, FINLAND
Dekati measurement solutions for occupational health and industrial hygiene include both portable and stationary PM measurement systems as well as solutions for overall industrial hygiene measurements according to ISO16000-34 and ISO16000-37. Our aerosol measurement solutions have been successfully used in various health and safety monitoring and research areas for over 25 years and today, our instruments are used globally by thousands of customers both in research and industry to measure different properties of ...
ByDekati Ltd. based in  Kangasala, FINLAND
As exhaust emissions from engine tailpipe have been decreasing in recent years through development of engines and exhaust after-treatment systems, non-exhaust emissions have become a major contributor to total particle emissions from vehicles. Numerous studies have shown that non-exhaust emissions can equal or even exceed those from the exhaust, and we have a measurement system for both types of emissions. Also, the discussions around Euro 7 emission standards has increased the interest and need for non-exhaust ...
ByDekati Ltd. based in  Kangasala, FINLAND
In urban environment the number of aerosol particles changes fast. The mass based measurements do not provide information about these fast temporal variations. Especially since most of the particles are ultrafine ones. Ultrafine particles might not contribute remarkably to the mass, but are important with respect to health ...
ByAirmodus Oy based in  Helsinki, FINLAND
With the advent of specific process emission limits being defined, continuous particulate monitoring has become a regulatory requirement for many industries. smoke stack #1Particulate monitoring requires the measurement of the mass concentration of particulate matter in stack emissions to atmosphere. There is no known method of continuously measuring particulate concentration by direct measurement and therefore, all continuous particulate measurement methods are inferential. Each method involves the ...
ByDynoptic Systems Ltd - ACOEM Group based in  Banbury, UNITED KINGDOM
The reasons for testing water quality in groundwater are numerous. Monitoring water quality and conducting tests is a good way to gather data on aquifer hydraulics. It can also be used to monitor parameters such as rhodamine, which helps to understand movement of underground water. Human activities can have an impact on groundwater quality, and conducting tests in this field can help to track these effects. Leachate from landfill and fertiliser can both find their way into groundwater. It is important to monitor ...
ByAquaread Ltd, Part of the NKE Group based in  Broadstairs, UNITED KINGDOM
Many large combustion plants are now required to monitor mass emissions of major pollutants and to do so requires an accurate measurement of stack gas velocity. The VCEM 5100 is certified to EN 15267 part 3 QAL 1 for all industrial processes including waste incineration. It has several key advantages, firstly the sensors optics are not in contact with the hot and dusty environment, the VCEM 5100 can monitor gases at temperatures exceeding 10000C and the analyser requires minimal maintenance. The VCEM 5100 can be ...
ByCodel - a Forbes Marshall company based in  Bakewell, UNITED KINGDOM
The TunnelTech 200 series are primarily gas monitors with optional Visibility capability. Most use Infra-red absorption technology to monitor gaseous pollutants and those with a visibility channel use optical attenuation for that application. All TunnelTech 200 analysers except the TunnelTech 205 use the same rugged corrosion resistant enclosures and have an optional Data Display unit. As there is only one moving part so reliability levels are very high and maintenance levels very ...
ByCodel - a Forbes Marshall company based in  Bakewell, UNITED KINGDOM
In some countries they do not allow tunnel atmosphere monitors to be mounted on the tunnel wall; also, where there is a single bore it is very difficult to gain access for maintenance purposes. The TunnelTech 400 series are extractive gaseous pollutant and visibility monitors and extract a gas and dust sample from the tunnel bore and carry to a remote analyser. This allows maintenance to take place without affecting tunnel traffic ...
ByCodel - a Forbes Marshall company based in  Bakewell, UNITED KINGDOM
There are strict regulations in place surrounding waste water, which makes it very important to monitor. Even small changes in aquatic ecosystems can have a huge impact in the chemical makeup of water, temperature, etc. By using real time monitoring on water quality, pollutants can be detected and mitigated before they pose a potential threat to these ecosystems and enter the water course. The rugged AP-2000 allows for real time testing of wastewater and helps to minimise risk of any potential fines. It is works ...
ByAquaread Ltd, Part of the NKE Group based in  Broadstairs, UNITED KINGDOM
Air quality monitoring is a critical task globally due to the widespread concern over air pollution. It is vital to monitor air quality to ensure that individuals and the environment are not exposed to hazardous concentrations of specific gases and ...
ByCirrus Research plc based in  Hunmanby, UNITED KINGDOM