Show results for
Refine by
So2 Product Applications In Italy
59 applications found
Premium
The measurement of pollutants such as O3, NO, NO2, CO, SO2 and HC to ppb’s and ppm’s require very sensitive analysers. ...
ByLNI Swissgas based in Torreglia (PD), ITALY
Premium
Process monitoring at a sulfuric acid plant requires good and reliable detection of, among other things, sulfur dioxide (SO2) in gas phase. This can be a challenge due to high concentrations of SO2, high temperatures, and high pressure. Monitoring may be needed at several locations in the process where SO2 concentrations may vary from a few mg/m3 to several percent by volume. ...
ByOPSIS AB based in Furulund, SWEDEN
ByAMETEK Process Instruments based in Pittsburgh, PENNSYLVANIA (USA)
Premium
An alternative that makes it possible to continue using high-sulfur oil as fuel is to install SO2 scrubbers that clean the flue gases to the same level as if the ships were fueled with low-sulfur oil. However, the scrubbers must be monitored by measuring the ratio of SO2 to CO2 concentrations. Here, OPSIS has a certified, cost-effective, and reliable ...
ByOPSIS AB based in Furulund, SWEDEN
Tail Gas Scrubber Process Information: The SO2 conversion rate of single absorption plants is lower than double absorption, and many single absorption plants installed tail gas scrubbers to reduce this SO2 content rather than convert the plant to double absorption. Scrubbing the tail gas (tail gas scrubbing) to acceptable SO2 emission values can be done with seawater, caustic, lime slurry, hydrogen peroxide or ammonia. After exiting the absorber tower, the gas ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
Most large coal fired plants have a flue gas desulphurisation (FGD) plant to lower SO2 levels to below emission limit levels. The CODEL GCEM 40 series is used to monitor SO2 levels after the FGD to ensure they are below required levels and to ensure that the process is not too efficient and using too much sorbent. ...
ByCodel - a Forbes Marshall company based in Bakewell, UNITED KINGDOM
Premium
Among other things, nitrogen oxides (NOX) and sulfur (sulfur dioxide, SO2) are regulated. OPSIS has the instruments to monitor the ...
ByOPSIS AB based in Furulund, SWEDEN
Tri-Mer is also the leader in equipment for removing PM, SO2, and NOx from large-scale stationary diesel operations. Tri-Mer’s UltraCat Catalytic Filter system is the world’s premier dry technology for PM+ SO2+ ...
ByTri-Mer Corporation based in Owosso, MICHIGAN (USA)
Air or SO2 is dried with H2SO4 before being fed to the sulphur burner or converter. ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
Premium
In the case of emissions from ships, it may be of particular interest to monitor sulfur dioxide (SO2) levels near the stacks to confirm that low-sulfur oil is being used or that desulfurisation is activated. ...
ByOPSIS AB based in Furulund, SWEDEN
Production of aluminum from its ores at aluminum smelters results in carbon dioxide CO2, carbon monoxide CO, sulfur dioxide SO2, and hydrogen fluoride HF gas emissions to the atmosphere. Read about our solutions for aluminum ...
ByGasmet Technologies - a Nederman company based in Vantaa, FINLAND
Most large coal fired power plants and combustion processes are required to monitor CO, NO and NO2 (NOx), SO2 and possibly CO2; in addition the analyser has to be normalised to Standard conditions. ...
ByCodel - a Forbes Marshall company based in Bakewell, UNITED KINGDOM
In the United States, Tri-Mer Catalytic Filter Systems readily meet EPA and state requirements for particulate (PM), SO2, HCl, metals, and ...
ByTri-Mer Corporation based in Owosso, MICHIGAN (USA)
As a result, according to EU statistics, ships have become the single biggest source of sulphur dioxide (SO2) within the EU. The US EPA (US Environmental Protection Agency) reports similar findings, i.e., that the proportion of air pollutants released which can be attributed to the shipping industry is increasing. ...
ByCodel - a Forbes Marshall company based in Bakewell, UNITED KINGDOM
Typical applications include live on-board exhaust monitoring (CO, CO2, N2O, NOx, formaldehyde, acetaldehyde, oxygen and moisture), analysis of raw and dilute exhaust gas from the engine and tailpipe with gas-bags (CO2, N2O, NOx, CH4, EtOH, THC, H2S, SO2, NH3, formaldehyde and acetaldehyde), diesel Selective Catalytic Reduction (SCR) after-treatment monitoring (NH3) and the Sealed Housing for Evaporative Determination ...
ByGasera Ltd based in Turku, FINLAND
Premium
Method allows determination of mass concentration of total sulfur dioxide (sulfurous acid and its salts, food additives E220–E228) in wine, wine materials, beer and beer products by capillary electrophoresis (CE) using capillary electrophoresis system “CAPEL® -105M”. The mass concentration of total sulfur dioxide is regulated by normative documents to be held within 100– 400 mg/L for different types of wine and wine materials and within 20–50 mg/L for beer products. According to ...
ByLumex Instruments based in Mission, BRITISH COLUMBIA (CANADA)
Premium
Second Sight TC provides temporary continuous monitoring during turnarounds, allowing cameras to be moved to focus on specific ...
ByBertin Technologies based in Montigny-le-Bretonneux, FRANCE
Premium
OPSIS non-contact monitoring solutions, based on either DOAS or TDL techniques, are very well suited for applications in the mining and smelting Industries, as the flue gas conditions often involve high temperatures and high dust ...
ByOPSIS AB based in Furulund, SWEDEN
Premium
Various types of sulfur compounds often arise during the production of paper pulp. There are emission limits and monitoring requirements, often expressed as total reduced sulfur, TRS. TRS includes hydrogen sulfide, H2S, and the sulfur compounds methyl mercaptan, dimethyl sulfide, and dimethyl disulfide. OPSIS offers systems to monitor both H2S and ...
ByOPSIS AB based in Furulund, SWEDEN
Premium
Monitoring the air quality at and around airports can be done for several reasons. It may be a question of monitoring the pollutants that employees and passengers are exposed to, but it may also be a matter of studying the contribution of aviation and ground traffic to pollution. Regardless of purpose, monitoring can be a challenge. The location of the measurement site must be representative. A large number of gaseous components need to be monitored with high accuracy and high ...
ByOPSIS AB based in Furulund, SWEDEN