Refine by
Industries served
- Manufacturing, Other
- Agriculture
- Water and Wastewater
- Construction & Construction Materials
- Oil, Gas & Refineries
- Medical / Health Care
- Monitoring and Testing
- Environmental
- Chemical & Pharmaceuticals
- Air and Climate
- University / Academia / Research
- Energy
- Mining
- Pulp & Paper
- Food and Beverage
- Waste and Recycling
- Automobile & Ground Transport
- Electronics and Computers
- Glassware
- Metal
- Communications / Telecom / Datacom
- Travel & Leisure
- Defense
- Forestry & Wood
- Retail
- Commercial
- Paint
- Maritime/Shipbuild/Water Transport
- Health and Safety
- Soil and Groundwater
- Government
Xprt Product Applications In Qatar
254 applications found
Premium
With over 20 years of experience in the measurement of volatile organic compounds (VOC), ENVEA announces the VOC72e, a new generation analyzer for the measurement of BTEX compounds by gas chromatography with photo-ionization detector (PID). The VOC72e can handle up to 40 compounds and eight configurations for analysis. This compact and fully automated analyzer with wide measurement ranges provides equivalent performance to the laboratory chromatographs and is particularly suited to fixe or mobile ambient air ...
ByENVEA based in  Poissy, FRANCE
Premium
OPSIS offers flexible monitoring of particles in the ambient air, both for determining the concentrations in real time and through collection on filters that are also preserved and can be used to determine the composition of the ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
How clean is the ambient air in our cities? A common strategy for monitoring the air quality in a city is to measure at ground level where people actually live and are at risk of exposure to air pollution. Often, there is also a requirement that the measurements are made in a place where you can expect the air pollution to be relatively high, which often means along one of the city's busier streets. Limit values for air quality often apply precisely to these locations. OPSIS offers several monitoring systems for ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
The almost closed environment means that high levels of air pollution often occur inside the tunnels. The limit values for the pollutants are often higher in tunnels than in open ambient air because the exposure time is normally limited, but it may still be necessary to monitor that the limit values are not exceeded. Traffic tunnels often have to be provided with ventilation to keep the levels of air pollutants below the applicable limit values. To save energy, however, it is common not to operate the fans more ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Air pollution at regional and national scales. It is important to monitor air pollution where many people stay, i.e. in cities and especially at street level. In order to better understand where the pollution comes from, a so-called background monitoring may also be needed. Then the monitoring station is placed in the countryside, at a great distance from obvious sources of the ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Monitoring of fugitive emissions from industrial facilities. Most of the OPSIS gas analysis systems are based on monitoring methods with open measurement paths. This provides a perfect tool for monitoring the air quality and detecting any gas leaks from industrial facilities so that staff and nearby residents can be alerted and measures can be taken ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
A challenging environment for monitoring instruments. Process control and emissions monitoring at a fertilizer plant can be difficult due to aggressive process gases in high concentrations, sometimes at high temperatures and pressures. Use of extractive monitoring systems in such an environment requires a lot of maintenance and the instruments are prone to malfunction. However, unlike extractive systems, OPSIS non-contact monitoring technology has no problem handling these ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Various types of sulfur compounds often arise during the production of paper pulp. There are emission limits and monitoring requirements, often expressed as total reduced sulfur, TRS. TRS includes hydrogen sulfide, H2S, and the sulfur compounds methyl mercaptan, dimethyl sulfide, and dimethyl disulfide. OPSIS offers systems to monitor both H2S and ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Challenging conditions for gas analysis at waste-to-energy facilities. Process and emissions monitoring at waste-to-energy plants or plain waste incineration plants can be a challenge. A large number of gas components need to be monitored with high accuracy. The flue gas is often aggressive and has high dust and moisture content. Close to 100% uptime is required, the monitoring system must be easy to maintain, and it must be able to be calibrated quickly. The OPSIS monitoring system handles all these challenges ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Port environments can be particularly exposed to air pollution, both in gaseous form and as particles. The ships are an obvious source, but both activities related to the unloading and loading of goods and land traffic to and from the ports can also contribute. Monitoring the concentration of air pollutants can be done both in order to monitor the environment in general and to map the sources. In the case of emissions from ships, it may be of particular interest to monitor sulfur dioxide (SO2) levels near the ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Gas analysis in brick manufacturing: Process control and emissions monitoring at brick plants can be challenging due to high concentrations of hydrogen fluoride (HF) and dust. The use of extractive monitoring systems in such environments requires a lot of maintenance and can still cause major operational disruptions. However, the contactless technology offered by OPSIS solves the ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Demanding monitoring environment at cement industries. Process control and emissions monitoring at a cement plant can be a challenge due to high dust levels and corrosive gases. OPSIS offers gas analysis systems that can handle these environments and that have high accuracy, short response times, and long maintenance ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
'Chemical industry' can comprise many types of industries, for example refineries, paper mills, fertilizer production, and sulfuric acid plants. Each individual industry may have its own special needs and special environments, but there are also many common factors. Regardless, process control and emissions monitoring at chemical plants can be challenging due to for example toxic, aggressive and/or explosive gases, and high temperatures. The use of extractive systems in such environments requires a lot of ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
The high temperatures in glass manufacturing can make it difficult to monitor gas concentrations for process control and emissions monitoring. However, OPSIS offers monitoring systems that handle the high temperatures in an excellent way. ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Process control and emissions monitoring in a mineral wool plant is a challenge due to the presence of phenol and formaldehyde. To use an extractive system in this environment will demand a lot of maintenance. The OPSIS DOAS system is different and provides plants with an accurate analyser that will operate with a minimum of maintenance. The OPSIS DOAS system is based on a non-contact method using an optical measurement path that can operate across the ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Make more out of your mill. OPSIS tested and approved monitoring systems provide cost-effective and reliable on-line monitoring of several gas compounds, such as both high and low concentrations of methane, moisture, carbon dioxide and hydrogen sulphide, at several ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
The nature of steel manufacturing processes places severe limitations on the monitoring methods that can be used. Aggressive environments combined with high levels of particulates and gases make the choice very ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
A tough environment requires toughened monitoring equipment. Process monitoring at a sulfuric acid plant requires good and reliable detection of, among other things, sulfur dioxide (SO2) in gas phase. This can be a challenge due to high concentrations of SO2, high temperatures, and high pressure. Monitoring may be needed at several locations in the process where SO2 concentrations may vary from a few mg/m3 to several percent by volume. Not all monitoring systems can handle these conditions and those that do ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Monitoring elemental and total mercury. There is a risk of toxic mercury being released into the air at for example waste incineration and cement production, and from coal-fired thermal power plants. To prevent this, there are requirements for flue gas treatment with low emission limits, and requirements for monitoring of the levels not exceeding these limits. OPSIS offers well-proven and certified systems for the required monitoring of mercury levels, both elemental mercury and the mercury compounds collectively ...
ByOPSIS AB based in  Furulund, SWEDEN
Premium
Combustion in boilers, gas turbines, waste to energy, paper-mills, minerals, etc. | MIR 9000e Customer: Any industry having a stake in improved combustion technologies Material measured: Combustion flue gases Installation: At the boiler outlet Function: Reliable and accurate monitoring of O2 and CO for combustion control optimization ...
ByENVEA based in  Poissy, FRANCE