Show results for
Refine by
Burner Product Applications In Florida
9 applications found
Premium
To improve quality in your manufacturing process, precision burner control is imperative. Our specially engineered ultra-low pressure drop mass flow controllers drastically minimize pressure drop, so the pressure at the burner tip better simulates the pressure from the gas. ...
BySierra Instruments, Inc. based in Monterey, CALIFORNIA (USA)
Premium
This involves measurements within the ammonia burner to detect ...
ByLAND® based in Dronfield, UNITED KINGDOM
Premium
Clean coal technology relies on our high temperature thermal flow meters to measure preheated combustion air in the large ducts feeding to the coal fired burners for maximum efficiency. Our vortex flow meters are ideal for steam, water and air flows as ...
BySierra Instruments, Inc. based in Monterey, CALIFORNIA (USA)
Premium
Sierra Instruments manufactures mass flow meters and controllers to help burner control systems run at peak efficiency. Use our Mass Flow Controller Selection Chart to find the right measurement solution for your ...
BySierra Instruments, Inc. based in Monterey, CALIFORNIA (USA)
If the limit values are exceeded, the conductivity limitation ensures prompt switching off of the burner(s). Foreign substances that have sunk to the bottom of the boiler are removed by briefly opening a drainage ...
ByIGEMA GmbH based in Münster, GERMANY
They are usually eliminated by passing them through an incinerator or by using them as fuel in the burner of a boiler or kiln. The incinerator, boiler or kiln however can be damaged by NCG’s which have built up explosive levels. ...
ByControl Instruments Corporation (CIC) based in Fairfield, NEW JERSEY (USA)
Premium
Optical fiber preform and fiber drawing processes. Optical fibres are used to transmit data using pulses of light. High-quality fibre is required for reliable telecommunications, and this quality is dependent upon precise temperature measurements at key ...
ByLAND® based in Dronfield, UNITED KINGDOM
In Fluid Catalytic Cracking (FCC) processes, widely used in oil refineries, the separation and recovery of powder catalysts is a major concern. Particularly, the concentration of catalyst after the FCC regenerator is usually over 150 mg/Nm3. Since these levels of emissions didn't represent any environmental harm in the past, they were not controlled by any separator or filter. Plant managers main concern was to clean a fraction of the gas to produce energy in a Turbo Expander, or similar, while concentrating the ...
ByAdvanced Cyclone Systems, S. A. (ACS) based in Porto, PORTUGAL
Calcination is a process that involves heating a substance, typically a solid material, at high temperature with limited supply of air or oxygen. The purpose of calcination is to remove volatile components and drive off impurities or to transform the material into a more desirable form for further ...
ByAdvanced Cyclone Systems, S. A. (ACS) based in Porto, PORTUGAL