- Home
- usa michigan
- Applications
Refine by
Industries served
- Monitoring and Testing
- Manufacturing, Other
- Water and Wastewater
- Energy
- Air and Climate
- Construction & Construction Materials
- Oil, Gas & Refineries
- Mining
- Agriculture
- Automobile & Ground Transport
- Metal
- Glassware
- Medical / Health Care
- Environmental
- Chemical & Pharmaceuticals
- Pulp & Paper
- Health and Safety
- Plastics & Resins
- Food and Beverage
- Electronics and Computers
- Aerospace & Air Transport
- Soil and Groundwater
- Commercial
- Printing
- University / Academia / Research
- Waste and Recycling
- Maritime/Shipbuild/Water Transport
- Travel & Leisure
- Defense
- Packaging
- Paint
- Communications / Telecom / Datacom
- Textile
- Government
- Forestry & Wood
Xprt Product Applications In Michigan
793 applications found
Premium
Anyone and everyone who is responsible for operating and maintaining a swimming pool or spa has to test, monitor, and control complex, interdependent chemical factors that affect the quality of water bathers are immersed in. Additionally, aquatic facility operators must be familiar with all laws, regulations, and guidelines governing what these parameters should ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Osmosis is the phenomenon of water molecules passing through a semi-permeable membrane from a region with lower dissolved solids to a region with higher dissolved solids until a near equilibrium is reached. Reverse Osmosis (RO) is a membrane process of purification which removes most of the total dissolved solids (TDS) in water by reversing the natural process of osmosis. Pressure is applied to a TDS-concentrated solution against a semi-permeable membrane, causing pure water to diffuse through the membrane. RO has ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Proper rinsing is one of the most important steps in quality manufacturing or metal finishing. Plenty of low cost, good quality water for rinsing has been available in the past, so rinse water conservation has been largely ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Boilers and cooling towers share two major water related problems: deposits and corrosion. As steam is generated by a boiler or water evaporating from a cooling tower, dissolved minerals are left behind, increasing the concentration of these minerals. Additional minerals are introduced via the water added to makeup the water lost to steam/evaporation. Eventually, the minerals reach a level (or cycle) of concentration that will cause either loss of efficiency due to scale or damage from corrosion. This level can be ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Contamination of circuit boards can bring about severe degradation of insulation resistance and dielectric strength. Cleanliness of completed circuit boards is, therefore, of vital interest. For those companies who have established circuit board cleaning procedures, the MIL Spec P-a has been used as a guideline for control. Now a simple “on line” test for the relative measurement of ionic contamination has been ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Accurate fountain (dampening) solution concentration control is essential for consistent, high-quality results in lithography. Low concentration can cause drying on the non-image area of the plate resulting in tinting, scumming, blanket piling, etc. High concentrations, on the other hand, bring about over-emulsification of the ink. This results in weakening of color strength and changes in ink rheology (body and flow properties). Correct concentration will allow the non-image areas of the plate to be appropriately ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Keeping the water in our lakes, rivers, and streams clean requires monitoring of water quality at many points as it gradually makes its way from its source to our oceans. Over the years ever increasing environmental concerns and regulations have heightened the need for increased diligence and tighter restrictions on wastewater quality. Control of water pollution was once concerned mainly with treating wastewater before it was discharged from a manufacturing facility into the nation’s waterways. Today, in ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Modern growing practices include scientific evaluations of soil, water, fertilizers, diseases, etc. While some tests are best performed by a laboratory, others can be easily conducted on location, saving time and money. Three tests in particular, EC, pH, and ALKALINITY, can reveal valuable information about water quality, soil salinity, and fertilizer concentration. Myron L® Company’s portable AGRI-METERS™ provide you with a simple, fast, and accurate means of testing these ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
“A technique of growing plants in nutrient solution”. Hydroponics literally means water-working or water- activation. It is a cultivation technique for growing plants in highly oxygenated, nutrient enriched water, rather than soil. The nutrient solution and its management are the cornerstone for a successful hydroponics system. The function of a hydroponics nutrient solution is to supply the plant roots with water, oxygen and essential mineral elements in soluble form. In soil, biological decomposition ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Controlling dialysate quality is critically important to hemodialysis patient health. Complications as minor as nausea and fatigue or as severe as metabolic acidosis and sepsis can result if dialysate composition is incorrect. All the factors that ultimately affect dialysate composition must therefore be carefully monitored and controlled: proper proportioning and mixing of concentrates with water; the quality of water mixed with concentrates to form dialysate; and the quality of water used in the reprocessing of ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
The economic efficiency of modern wastewater treatment plants is significantly influenced by the energy consumption of the various process steps during wastewater treatment. The energy-intensive process of biological aeration is a particular focus of attention in this regard: around 60 to 80 percent of the total energy requirement is generated here. At the same time, wastewater tank aeration offers great energy-saving potential that can be exploited by operators of wastewater treatment ...
ByAerzener Maschinenfabrik GmbH based in  Aerzen, GERMANY
Premium
Water treatment is undergoing a profound transformation and is gaining in importance worldwide. Water is an increasingly scarce commodity. Particularly in poorer countries, it is not available in sufficient quantities. Bottlenecks are becoming more and more severe due to growing demand on the part of industry, agriculture and energy generation. Although problems such as water scarcity are of limited relevance here in Germany, a responsible, resource-saving approach to water is an important issue for the future. ...
ByAerzener Maschinenfabrik GmbH based in  Aerzen, GERMANY
Premium
Focuses on medium NOx, NOx-related and multigas-concentrations up to 5’000 ppm where flexibility is a central requirement. Parameters included are NO, NO2, NOx, NH3, NOx-amines, O2 and CO2. Typical supported applications are industrial emission monitoring and gas manufacturing control. ...
ByECO Physics AG based in  Duernten, SWITZERLAND
Premium
Focuses on high NOx, NOx-related and multigas-concentrations up to 10’000 ppm. Parameters included are NO, NO2, NOx, NH3, NOx-amines, O2 and CO2. The applications are characterized by demanding sample gas conditions, such as in automotive, aviation, naval, or combustive engine emissions, as well as in catalyst production. ...
ByECO Physics AG based in  Duernten, SWITZERLAND
Premium
NOx detection is an innovative approach in CMP (Chemical Mechanical Polishing) process control. CMP smoothens the wafer surface with a combined chemical and mechanical polishing procedure. During production, wafers are coated by a thin layer. To avoid damage to the wafer surface, for instance by stress cracks, the NOx emitted as soon as the wafer is plane and blank must be measured. Therefore, a high-resolution NOx-detector, capable of determining exactly when the polishing process must be stopped, is essential. ...
ByECO Physics AG based in  Duernten, SWITZERLAND
Premium
Chemiluminescense based analyzer for NO in ...
ByECO Physics AG based in  Duernten, SWITZERLAND
Premium
Focuses on low NOX and NOX-related concentrations up to 100 ppm where high resolution is required. Parameters included are NO, NO2, NOX, NH3, NOX-Amines and NOY. Target applications are ambient air monitoring, indoor measurement, clean room measurement and atmospheric ...
ByECO Physics AG based in  Duernten, SWITZERLAND
Premium
In the era of Industry 4.0, automated machine regulation has come to play an increasingly important role in waste water management. Digital control systems depend on measurement values that are constantly recorded by sensors and have become significantly faster, more accurate and more precise than a manual control system could ever be. AERZEN control technology offers a wide range of options and implements optimal automated machine control, including for third-party products. There is tremendous potential for ...
ByAerzener Maschinenfabrik GmbH based in  Aerzen, GERMANY
Premium
As market leader in the field of water treatment, AERZEN has developed trend-setting concepts that support plant constructors, engineers and operators of wastewater treatment plants in areas such as the selection of technology, increasing efficiency, process safety, data analysis, digitisation, conserving resources, increasing productivity and much more. Summarised under the term AERwater, we offer a holistic solution approach with finely tuned service module via a tight linkage of hardware, software and ...
ByAerzener Maschinenfabrik GmbH based in  Aerzen, GERMANY
Premium
According to a study by the German Environment Agency , wastewater treatment plants are responsible for around 1% of Germany's total electricity consumption. What initially sounds like a very small percentage, however, offers a highly attractive savings potential from the point of view of individual wastewater treatment plant operators. One typical example of the savings potential in wastewater treatment plants is tank aeration. For example, state-of-the-art blower technologies and demand-driven control technology ...
ByAerzener Maschinenfabrik GmbH based in  Aerzen, GERMANY