- Home
- Applications
- usa missouri
- water sampling
Refine by
Water Sampling Product Applications In Missouri
13 applications found
These polar compounds are hydrophilic, so they may find their way into drinking water sources. While gas chromatography has historically been the preferred technique for analysis of herbicides in water samples, the use of LC-MS/MS for this application is gaining acceptance. ...
BySigma-Aldrich based in Bellefonte, PENNSYLVANIA (USA)
Ideally, a continuous online monitor would be used for collecting data to determine upset frequencies, duration and normal conditions. Many of the SWD facilities and demonstration plants do not have a budget that allows for continuous monitoring. However, high frequency sample analysis can be performed on site, using a portable analyzer. Easy to use, low cost field analyzers, such as the TD-500D, are essential for optimizing the effectiveness of treatment systems during pilot studies and meeting a budget that ...
ByBenchmark Measurement Solutions (formerly Turner Designs Hydrocarbon Instruments) based in Edmonton, ALBERTA (CANADA)
The Solution: Numerous technologies and products were evaluated for this application. A monitor with no moving parts, no significant effect from turbidity, and the ability to detect the lube oil at less than 1 ppm was determined to be the best solution. Fast, reliable, and accurate detection of lubricating oil in the water was ...
ByBenchmark Measurement Solutions (formerly Turner Designs Hydrocarbon Instruments) based in Edmonton, ALBERTA (CANADA)
Sampling requirements in the water and waste water treatment industry demand safe and reliable pump control. Many sampling applications require a suction lift. There is no better suction lift than that achieven using a peristaltic oump which lift up to 30 feet. Watson-Marlow pumps are perfect for automatic or manual sampling at the different stages of the treatment process. They accept PROFIBUS RS232, RS485, 4-20mA and 0-5V signal ...
ByWatson-Marlow Fluid Technology Group based in Falmouth, UNITED KINGDOM
The Situation: California is currently facing one of the most severe droughts in recorded history. In order to mitigate the drought conditions, various water conservation measures have already been implemented, and others are being considered. One method under consideration is using the advanced treatment of produced water to make it available for irrigation. A major challenge to the success of this method is economically treating the produced water to achieve the quality mandated by California’s irrigation ...
ByBenchmark Measurement Solutions (formerly Turner Designs Hydrocarbon Instruments) based in Edmonton, ALBERTA (CANADA)
The Situation:Power plants and paper mills use service water loops and mill water loops respectively for the cooling of lubricating, hydraulic, turbine and transformer oil. These cooling systems feature large, recirculating volumes of water which are treated with biocides, dispersants, and corrosion inhibitors. By comparison, refineries often use once through cooling water systems. The cooling water is taken from lakes, rivers, or the ocean and circulated once through the plant to cool processes. Large volumes of ...
ByBenchmark Measurement Solutions (formerly Turner Designs Hydrocarbon Instruments) based in Edmonton, ALBERTA (CANADA)
The Problem: To protect the river environment, the sumps at some advanced locations have oil in water separation systems and oil in water monitors. The installation of a TD-4100 series monitor in these applications is very simple. All that is needed is a properly plumbed sample stream and a way to drain the water back to the sump. A dry air supply is also needed to prevent fogging within the non-contact falling stream flow ...
ByBenchmark Measurement Solutions (formerly Turner Designs Hydrocarbon Instruments) based in Edmonton, ALBERTA (CANADA)
Power plants, paper and steel mills and other industries with rotating equipment often use recirculated water for the cooling of lubricating, hydraulic, turbine and transformer oil. If an oil cooler leaks, the loss of oil can cause significant damage to the pumps, compressors and motors. High oil & grease water discharge test results can be caused by oil contamination. In some cases, air quality issues can also occur. A UV fluorescence oil in water monitor from Turner Designs Hydrocarbon Instruments can ...
ByBenchmark Measurement Solutions (formerly Turner Designs Hydrocarbon Instruments) based in Edmonton, ALBERTA (CANADA)
The Situation: A wastewater treatment company operated an oil/water separation facility on a multi-acre industrial site in Northern California. Its purpose was to recycle oil products for profit while at the same time providing a wastewater treatment service for industries based in Northern California. The oily water mixes processed by the company were obtained from tanker bilges, contaminated rainwater runoff, truck spills, oil spills into waterways, crankcase drain oils, hydraulic oils and industrial lubricants, ...
ByBenchmark Measurement Solutions (formerly Turner Designs Hydrocarbon Instruments) based in Edmonton, ALBERTA (CANADA)
The economic advantage of continuous discharge could only be achieved at this location by meeting strict discharge limits for the level of hydrocarbons present in the discharged water. Local ordinances required continuous monitoring for continuous discharge of the company’s treated ...
ByBenchmark Measurement Solutions (formerly Turner Designs Hydrocarbon Instruments) based in Edmonton, ALBERTA (CANADA)
Our lab is certified and equipped to serve our clients by identifying pathogens from samples obtained from soil, water and plants. A variety of tests can be offered for pathogens detection and pathogen identification in the lab. ...
ByPluton Biosciences, Inc. based in St. Louis, MISSOURI (USA)
The Oil in Water Analyzer combines the PX2+ with our Front Surface Fluorescence Probe to create an analyzer that continuously and accurately measures the presence of oil in water. The all-inclusive Oil in Water Analyzer come preassembled with a PX2+ photometer attached to our Front Surface Fluorescence Probe via fiber optic cables. The analyzer is less susceptible to noise due to bubbles, reabsorption, and turbidity in the sample. The Oil in ...
ByCustom Sensors & Technology (CST) based in Fenton, MISSOURI (USA)
The Water in Ethanol Analyzer continuously measures water concentration in alcohol and displays the concentration on the unit’s touch screen display in real-time. The all-inclusive Water in Ethanol Analyzer comes preassembled in a waterproof NEMA4X enclosure with a dedicated sample flow cell outside of the enclosure. ...
ByCustom Sensors & Technology (CST) based in Fenton, MISSOURI (USA)