- Home
- usa oregon
- Applications
Refine by
Industries served
- Manufacturing, Other
- Agriculture
- Energy
- Water and Wastewater
- Medical / Health Care
- Environmental
- Mining
- Oil, Gas & Refineries
- Construction & Construction Materials
- Glassware
- Commercial
- Air and Climate
- Food and Beverage
- Aerospace & Air Transport
- Metal
- Pulp & Paper
- Textile
- University / Academia / Research
- Automobile & Ground Transport
- Monitoring and Testing
- Electronics and Computers
- Waste and Recycling
- Communications / Telecom / Datacom
- Health and Safety
- Retail
- Packaging
- Paint
- Plastics & Resins
- Chemical & Pharmaceuticals
- Government
Xprt Product Applications In Oregon
297 applications found
Premium
Anyone and everyone who is responsible for operating and maintaining a swimming pool or spa has to test, monitor, and control complex, interdependent chemical factors that affect the quality of water bathers are immersed in. Additionally, aquatic facility operators must be familiar with all laws, regulations, and guidelines governing what these parameters should ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Osmosis is the phenomenon of water molecules passing through a semi-permeable membrane from a region with lower dissolved solids to a region with higher dissolved solids until a near equilibrium is reached. Reverse Osmosis (RO) is a membrane process of purification which removes most of the total dissolved solids (TDS) in water by reversing the natural process of osmosis. Pressure is applied to a TDS-concentrated solution against a semi-permeable membrane, causing pure water to diffuse through the membrane. RO has ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Proper rinsing is one of the most important steps in quality manufacturing or metal finishing. Plenty of low cost, good quality water for rinsing has been available in the past, so rinse water conservation has been largely ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Boilers and cooling towers share two major water related problems: deposits and corrosion. As steam is generated by a boiler or water evaporating from a cooling tower, dissolved minerals are left behind, increasing the concentration of these minerals. Additional minerals are introduced via the water added to makeup the water lost to steam/evaporation. Eventually, the minerals reach a level (or cycle) of concentration that will cause either loss of efficiency due to scale or damage from corrosion. This level can be ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Contamination of circuit boards can bring about severe degradation of insulation resistance and dielectric strength. Cleanliness of completed circuit boards is, therefore, of vital interest. For those companies who have established circuit board cleaning procedures, the MIL Spec P-a has been used as a guideline for control. Now a simple “on line” test for the relative measurement of ionic contamination has been ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Accurate fountain (dampening) solution concentration control is essential for consistent, high-quality results in lithography. Low concentration can cause drying on the non-image area of the plate resulting in tinting, scumming, blanket piling, etc. High concentrations, on the other hand, bring about over-emulsification of the ink. This results in weakening of color strength and changes in ink rheology (body and flow properties). Correct concentration will allow the non-image areas of the plate to be appropriately ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Oxidation Reduction Potential or Redox is the activity or strength of oxidizers and reducers in relation to their concentration. Oxidizers accept electrons, reducers lose electrons. Examples of oxidizers are: chlorine, hydrogen peroxide, bromine, ozone, and chlorine dioxide. Examples of reducers are sodium sulfite, sodium bisulfate and hydrogen sulfide. Like acidity and alkalinity, the increase of one is at the expense of the ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Groundwater hydrology is an interpretive science: we can’t observe the aquifers directly so we must interpolate and extrapolate our understanding from water-level measurements taken from observation wells. Stevens has expertise for measuring both water quantity and water ...
ByStevens Water Monitoring Systems, Inc. based in  Portland, OREGON (USA)
Premium
Water resource management refers to the conservation, custody and transport monitoring of water as a natural resource. Measurements are made to quantify water for the purpose of protection, forecasting, management, lawmaking, enforcement, policymaking, resource allocation and public reporting. Stevens has been providing quality products for water management for over 100 ...
ByStevens Water Monitoring Systems, Inc. based in  Portland, OREGON (USA)
Premium
Weather is the state of the atmosphere that is driven by air pressure, temperature, and moisture differences between one place and another. Many geospatial variables influence such weather drivers. Understandings of what weather is, what makes it change, the effect it has different applications have existed for most of human history. Today, weather understanding, modelling, and forecasting are made by collecting quantitative data about the current state of the atmosphere, land, and ocean by using meteorology data ...
ByStevens Water Monitoring Systems, Inc. based in  Portland, OREGON (USA)
Premium
Keeping the water in our lakes, rivers, and streams clean requires monitoring of water quality at many points as it gradually makes its way from its source to our oceans. Over the years ever increasing environmental concerns and regulations have heightened the need for increased diligence and tighter restrictions on wastewater quality. Control of water pollution was once concerned mainly with treating wastewater before it was discharged from a manufacturing facility into the nation’s waterways. Today, in ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Modern growing practices include scientific evaluations of soil, water, fertilizers, diseases, etc. While some tests are best performed by a laboratory, others can be easily conducted on location, saving time and money. Three tests in particular, EC, pH, and ALKALINITY, can reveal valuable information about water quality, soil salinity, and fertilizer concentration. Myron L® Company’s portable AGRI-METERS™ provide you with a simple, fast, and accurate means of testing these ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
“A technique of growing plants in nutrient solution”. Hydroponics literally means water-working or water- activation. It is a cultivation technique for growing plants in highly oxygenated, nutrient enriched water, rather than soil. The nutrient solution and its management are the cornerstone for a successful hydroponics system. The function of a hydroponics nutrient solution is to supply the plant roots with water, oxygen and essential mineral elements in soluble form. In soil, biological decomposition ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Controlling dialysate quality is critically important to hemodialysis patient health. Complications as minor as nausea and fatigue or as severe as metabolic acidosis and sepsis can result if dialysate composition is incorrect. All the factors that ultimately affect dialysate composition must therefore be carefully monitored and controlled: proper proportioning and mixing of concentrates with water; the quality of water mixed with concentrates to form dialysate; and the quality of water used in the reprocessing of ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Years ago, high purity water was used only in limited applications. Today, deionized (Dl) water has become an essential ingredient in hundreds of applications including: medical, laboratory, pharmaceutical, cosmetics, electronics manufacturing, food processing, plating, countless industrial processes, and even the final rinse at the local car ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
The textile manufacturing industry encompasses many and diverse processes that rely heavily on the use of water, energy, chemicals, and other resources. Wet spinning, sizing, desizing, scouring, bleaching, mercerization, dyeing and printing are just a few. Monitoring and controlling the pH, TDS/Conductivity/Salt Concentration, ORP (REDOX), and Temperature of the aqueous solutions used in these processes conserves costly resources, controls quality, and reduces the amount of pollution that must be treated before ...
ByMyron L Company based in  Carlsbad, CALIFORNIA (USA)
Premium
Understanding the importance of soil continues to increase across various sectors. Soil monitoring and assessment are critical for a wide range of applications, including research, climate observation, water resource forecasting, groundwater management, stormwater control, agriculture, turf management for golf courses and sports fields, civil engineering, and property conservation. Integrating advanced soil measurement technologies with a commitment to environmental sustainability fosters resilience to climate ...
ByStevens Water Monitoring Systems, Inc. based in  Portland, OREGON (USA)
Premium
Bagging is a widely used system for storing and keeping a variety of cull products including beet pulp, orange peel, sweet corn and ...
ByVersa Corporation LLC based in  Astoria, OREGON (USA)
Premium
ByGeneral Oceanics Inc. based in  Miami, FLORIDA (USA)
Premium
Bagging alfalfa can eliminate the need to feed dry hay because it contains a higher percentage of dry matter. Alfalfa, clover, and grass breeds are cut approximately every 26 to 30 days. Legumes are cut at two inches and below, wilted to 60-70% moisture, and fermented to a low stable PH value. Legumes are richer in proteins than cereal grains. ...
ByVersa Corporation LLC based in  Astoria, OREGON (USA)