Refine by
Air Testing System Articles & Analysis
18 articles found
When performing pressure tests on pipelines, whether using air or water, proper connection and control equipment is essential for safety and test accuracy. Two small but critical accessories in PlugCo’s testing system are the Air Test Adaptor and the Air ...
Pipe plugs and pipe test plugs are essential tools for conducting tightness tests on newly installed or rehabilitated sewer and drain pipelines. The European Standard EN 1610 outlines the correct procedures for these tests to ensure reliability and ...
One tiny leak can mean big problems down the road. That is where air testing comes in, and specifically, testing that follows the EN 1610 standard. Air testing is quick, cost-effective, and cleaner than water testing. But like any pressurized system, it has its risks. That is ...
Cubic refrigerant gas analyzers can be widely used in multiple scenarios of refrigerant analysis, including the production process of HVAC equipment, verification tests in laboratories, and compliance testing by third-party testing agencies. ...
For companies with independent R&D capabilities, Cubic refrigerant gas analyzer can be applied in their own laboratories for sensor performance verification, leakage simulation testing, system air tightness testing, with in-depth analysis of the composition, concentration and change trend of refrigerant gas. In addition, ...
Abstract Wet electrostatic precipitation technology can be used to control acid mists, sub-micron particulate, mercury, metals and dioxins/furans as the final polishing device within a multi-pollutant air pollution control system. Test results from coal –fired installations demonstrate >90% removal efficiencies on PM2.5, SO3, and near ...
Also, the thermal cycling test chambers systems have high thermal air flow systems that utilize thermal testing, quick temperature cycling, and apparatus temperature characterization. ...
The following introduces our environmental test chamber systems, such as refrigeration system, heating system, and air supply system: Refrigerating system The generation of low temperature comes from the refrigeration system. ...
Octane Test Engine combustion air is drawn through the intake air system from the room where the engine is installed. The intake air system incorporates intake air humidity refrigeration unit. It includes an electric heater, and piping to direct the conditioned ...
This means that exhaust air filtration is extremely important, especially in light of the current coronavirus epidemic. And while FFP masks and various filters with a pore size of 0.2 μm are theoretically incapable of catching pure SARS-CoV-2 particles due to the small size of the particles (between approx. 0.1 and 0.14 μm), tests show that the exhaust ...
Direct reading measurements can also be made using an infrared spectrophotometer as a leak detector for the gas supply system or effective operation of the waste gas scavenging system. Air quality testing/sampling during surgical procedures do not allow for an industrial hygienist/air quality specialist to be in ...
OSHA reports that respirators protect workers in two basic ways: The first is by the removal of contaminants from the air. Respirators of this type include particulate respirators, which filter out airborne particles, and air-purifying respirators with cartridges/canisters, which filter out chemicals and gases. Other respirators protect by supplying clean ...
This study compared and evaluated the performance of a conventional membrane bioreactor (MBR) and a novel reciprocation MBR (rMBR) which used mechanical membrane reciprocation in place of membrane air scouring in pilot-scale tests. Each system was independently operated for 280 days at a local wastewater treatment plant for a parallel ...
Noise source identification is a prerequisite to the decrease in the interior noise. To study the effects of air conditioning system on the noise inside the high speed train, the comprehensive measurement of noise and vibration was made for different carriages of the high speed train. Analysis results of internal noise within different carriages in the running ...
There are two primary objectives in achieving acceptable air quality in the operating room: (1) control of anesthetic gases for the benefit of operating room staff, and (2) infection control for the benefit of the patient. ...
The aeration efficiency of two types of aeration devices, air injection and mechanical surface aerators was evaluated in farm dugouts in the Peace River Region of Alberta. The air injection systems were tested using three types of diffusers; open-ended tubing, linear fine bubble diffusers and a membrane diffuser. ...
Classical DAF and advanced hybrid centrifugal – dissolved air flotation (GEM) were pilot tested. Both systems performed well, but GEM removed FOG and TSS to lower amount and produced drier sludge. ...
This paper proposes a pragmatic methodology to manage the air quality of an air conditioned building as well as optimizing energy consumption during venting. ...