Ammonium Sensor Articles & Analysis
5 articles found
Capability to measure below 1ppm ammonium (total ammonia or NH3-N) in presence of common levels of potassium for secondary WWTP Capability to measure nitrate (NO3-N) even in the presence of high levels of chloride or nitrite ions without loss of linearity or stability Ammonia and nitrate measurements can be performed using just one analyzer Support for dual ammonia/ammonia, ...
We evaluated GPR at two WWTP monitoring problems: estimate missing data in a flow rate signal (simulated data), and detect a drift in an ammonium sensor (real data). We showed that GPR with the standard estimation method, maximum likelihood estimation (GPR-MLE), suffered from local optima during estimation of kernel parameters, and did not give satisfactory ...
Ammonium feedback control is increasingly used to determine the dissolved oxygen (DO) set-point in aerated activated sludge processes for nitrogen removal. This study compares proportional-integral (PI) ammonium feedback control with a DO profile created from a mathematical minimisation of the daily air flow rate. ...
Abstract: A pilot-scale activated sludge wastewater treatment plant (WWTP) operated with nitrification and pre-denitrification was monitored with a set of on-line sensors for over 3 years. Wet-chemistry ex-situ analyzers, UV and UV-Visible in-situ sensors and in-situ sensors based on ion-selective electrodes (ISE) were used. New ISE ...
Abstract: A pilot-scale activated sludge wastewater treatment plant (WWTP) operated with nitrification and pre-denitrification was monitored with a set of on-line sensors for over 3 years. Wet-chemistry ex-situ analyzers, UV and UV-Visible in-situ sensors and in-situ sensors based on ion-selective electrodes (ISE) were used. New ISE ...