Refine by
Grain Size Analysis Articles & Analysis
6 articles found
The analysis of fluorine with XRF is a continuous challenge, as the element is characterized by a very weak fluorescence yield, which leads to a low sensitivity [1]. In connection with this, is the very low depth of analysis for the fluorine Ka line of just a few micrometers in the samples to be analyzed. This results in very large errors in pressed pellets due ...
The off-line laboratory analysis of grain size in a material fl ow is timeconsuming and not suitable for the detection of a sieve failure arising in the short term. ...
ByENVEA
Soil and rocks: special, non-hazardous waste Type of analysis: Solid Waste Characterization; Thermal treatment; Landfill Leaching Test; Non-Hazardous Waste characterization, simplified procedure. - Grain Size Analysis - 1. Oversieve 10 mm - 0,6 % 2. Fraction 4-10 mm - 2,0 % 3. ...
An assessment of arsenic and vanadium pollution was investigated for surface sediments collected from 41 sampling stations along the Egyptian Mediterranean coast during summer 2008. Grain size analysis, Total Organic Carbon (TOC), total silicate and carbonate contents were also studied. ...
Fourteen sampling sites were selected along the coast and approximately 400 g of surficial sediments were obtained. Samples were sieved and three grain size fractions from each sample plus fourteen bulk samples were selected for the analysis of metals. Laboratory analysis of the samples utilized the Cold Acetic protocol, followed ...
This technical note describes a study on the effect of different dispersing agents and the quantity of same on the grain-size distribution and in particular the percentage of clay size. ...