Refine by
Heat Detector Articles & Analysis
6 articles found
The first cause of PIR false alarms is low or unstable voltage at the detector. Test to make sure the voltage at each PIR is above 13VDC and stable. The second cause of false alarms is sudden infrared movement / heat changes in view of the detector. 2.How do PIR sensors work? ...
The first cause of PIR false alarms is low or unstable voltage at the detector. Test to make sure the voltage at each PIR is above 13VDC and stable. The second cause of false alarms is sudden infrared movement / heat changes in view of the detector. 2. Do PIR sensors work in the dark? ...
Moreover the gas gest sets are including an automatic fire extinguisher CO2 system with gas leak, heat, flame, and smoke detectors. The gas gen set units are of the state of art technology in the world with low compression ratio engine to cope with the low flare gas quality with built in synchronizer and knocking detection system built in a 40 feet sound proof ...
However, plunge test results cannot be extrapolated to the response time in an operating plant because response time is affected by multiple factors such as the ratio of internal heat-transfer resistance to the surface heat-transfer resistance, or Biot Modulus. ...
The intent of this paper is to give a broad introduction to the selection and use of flame and gas detector technologies. We will answer questions such as these: When should a flame-detector solution use infrared vs. ultraviolet detectors? ...
While providing good accuracy and repeatability, electrochemical detectors are not resilient in high heat and in prolonged low-humidity conditions. ...