Isokinetic Stack Sampling Articles & Analysis
7 articles found
To design the most efficient system, an isokinetic dust sample was collected at the stack and measured by ACS in a laser sizer to obtain the Particle Size Distribution (PSD). ...
In order to design the most efficient system for this case, an isokinetic dust sample was collected at the stack and measured by ACS in a laser sizer to obtain the Particle Size Distribution (PSD). ...
The heat generation units supply 9 MKcal/h as thermo-fluid and 3.6 MKcal/h as vapour producing nearly 54.000 m3/h at 177ºC flow rate at the flue-stack. Emissions of particulates amounted to 1.240 mg/Nm3. The goal of ACC was to decrease it by a factor of 10, to under 100 mg/Nm3. In order to design the most efficient system for this case, an isokinetic dust ...
To design the most appropriate system for this case, a dust sample was collected through an isokinetic sampling at the stack of another plant with equivalent operating conditions. The sample was subsequently measured in a laser sizer to obtain the Particle Size Distribution (Fig. 2). ...
IDENTIFYING THE PROBLEM AND SOLUTION The existing cyclone after the dryer was not efficient enough to meet the Portuguese emission limit (150 mg/Nms). Measured emissions at the stack reached 1,625 mg/NmJ of total suspended particles (mass flow of 9 kg/h). ...
In order to design the most diffident system for this case, an isokinetic dust sample was collected at the stack and measured by ACS in a laser sizer to obtain the Particle Size Distribution (PSD). After stack tests confirmed the PSD (Fig.3), ACS designed a Hurricane system comprising 8 Hurricane HR numerically optimized ...
To overcome this problem, the sample for the scattered light measurement in the StackGuard is extracted from the stack and heated in a sampling line up to 160°C. ...