Refine by
Power Plant Performance Articles & Analysis
39 articles found
Figure 1The efficient and sustainable operation of photovoltaic (PV) systems is possible with accurate and reliable performance monitoring. The selection of photovoltaic (PV) sensors is of great importance for accurately monitoring GES performance. ...
From food safety to power-plant performance, these were the water challenges, technologies, and solutions driving the most attention in 2025 In a year defined by tightening regulations, rising water stress, and growing pressure on industries to do more with less, certain topics emerged as priorities for operators and industries navigating these ...
Wedge Wire Screen--Efficient filter systems for power generation In conventional power generation plants such as gas or nuclear power plants, industrial wedge wire screen filters ensure the long-term functionality and durability of the turbines and generators, maintaining compliance with ecological standards and ...
Challenge Fluctuations in a photovoltaics plant’s output are inherent and caused by various reasons. Without a quick and adequate reaction, plant operators lose time and money. In addition to that, underperformance of power plants may lead to penalties. Solution Precise on-site measurement of the current solar irradiance ...
RDF can be used as main or supplementary fuel in furnaces of cement plants, thermal power plants, metallurgical furnaces. The calculations performed showed the expediency of replacing gas or coal with RDF in the production of cement. ...
Clarke Energy has successfully completed a key milestone for Kalium Lakes Limited Beyondie Sulphate of Potash (SOP) mine in Western Australia. Now the project, one of the first of its kind in Australia, prepares for commencement of the process plant commissioning activities in the next few ...
Some examples are in the food and beverage industry, microchip rinse water, and power plant boiler water. The performance of EDI is extremely reliable because it provides remarkably high purity water production without needing to be taken offline intermittently, such as is necessary for its primary mixed bed chemical regeneration. ...
Whether you are monitoring discharges from power plants, remediation performance at contaminated sites or the environmental performance of chemical plants, chances are that you are working with various subcontractors for field sampling, laboratory analysis, data validation, and report generation. ...
Turbomachs solution was to provide a combined cycle power plant that has demonstrated excellent emissions ...
In addition, new anti-reflective coatings can be retrofitted to operational panels to reduce energy losses and increase output, he said. Plant upgrades Repowering of solar plants or revamping/retrofitting of PV plant components can also offer significant returns on investment, the guidelines will say. ...
The last operating coal-burning power station in Oregon, the relatively young, 550-MW plant has faced much pressure and scrutiny regarding its ultimate fate, which must be decided and underway by 2020. ...
Sulzer offers advanced mixing technology for flue gas cleaning. The installation in a large power plant shows that these high-performance mixers can cope with the most difficult requirements. ...
This study presents the effect of temperature, fouling factor and salinity of the condenser cooling seawater and adverse effect on the thermal performance of a nuclear power plant. These are the most important factors affecting the condenser performance. The study is carried out on a pressurised water reactor nuclear ...
CO2 capture by absorption requires solvents which can meet performance criteria such as fast absorption rate, high CO2 loading capacity, low regeneration energy, low degradation rate, low corrosiveness, low environmental impact and low solvent cost. The development of a suitable solvent is central for design of decarbonised power plants with ...
On the other hand, concentrating solar power plants represent 70% of the total power to be installed in the framework of the national plan of renewable energy and energy efficiency which consists of installing up 22,000 MW of power generating capacity from renewable sources between 2011 and 2030. In this purpose, this article ...
ABSTRACT Measuring campaigns at two Danish pulverised coal fired power plants has been performed. The power plants are equipped with the same type og flue gas cleaning devices. The concentrations and chemical compositions of the formed particles were similar for the two plants. The measurements ...
A comprehensive thermodynamic analysis of a conceptual integrated coal gasification combined cycle power plant is presented. Energy and exergy efficiencies and exergy destructions of each sub–unit are calculated. The effect of nitrogen, which is supplied from the Air Separation Unit (ASU) of the gasification unit to the combustion chamber of the gas turbine (GT) ...
The Need for Accounting Standards for Mitigation Policies and Goals To date, no standardized approach has existed for quantifying the GHG effects of policies and actions and tracking performance toward mitigation goals. For example, there is an ongoing debate on whether the United States is on track to meet its goal of reducing emissions by 17 percent below 2005 levels by 2020. ...
For combustion air and flue gas applications, some critical services are very dependent on rapid speed to ensure equipment life, operator safety and peak plant performance. At the Florida Power & Light 3-Unit Manatee Station, a 2,735 MW generating plant in Parrish, Florida, Rotork Type K damper drives have provided a solution ...
This power plant uses combined cycle and has a capacity of 174 MW. The application of the life cycle analysis (LCA) tool enables us to perform a quantitative and qualitative analysis of all environmental impacts of the plant. ...