Refine by
Pump Connector Articles & Analysis
10 articles found
Understand the Impact of Humidity on Concrete Pumps Before delving into maintenance and repair solutions, it's essential to understand how Singapore’s humid climate affects concrete pumps. ...
The EPA has determined that leaking equipment such as valves, pumps, and connectors are the largest source of emissions of volatile organic compounds (VOCs) from petroleum and chemical manufacturing facilities and contribute to ground level ozone. ...
The pump and panels are located at a small building erected especially to house the equipment. ...
” Access to Pumps a Key Access to a variety of pumps, hoses and connectors is key to serving the mining sector. ...
Other elements of the chemical industry enhanced LDAR requirements include the following: Certain technologies are required for repair of leaking valves and connectors Closure devices associated with open-ended lines must be monitored via Method 21 on a periodic basis More stringent delay of repair provisions were included Frequent periodic monitoring of certain valves, ...
the sub is the “wet” pump handling the ground water or effluent. The sub can pump in any orientation, either lying on the ground on its side, standing up, or even upside down. Lying sideways makes the pump easy to manipulate by hand. Subs can be outfitted with suction and discharge adapters with grooved restrained-joint ...
An LDAR program is a facility’s system of procedures used to locate and repair leaking components (e.g., valves, pumps, connectors, compressors, and agitators) to minimize fugitive volatile organic compounds (VOC) and hazardous air pollutants (HAP) emissions. ...
Beginning in the 1980s, EPA called for the implementation of LDAR programs for control of fugitive VOC emissions (i.e., emissions from piping components such as flanges, connectors, valves, pumps, etc.). Therefore, LDAR requirements were initially promulgated in the New Source Performance Standards (EQ_Q2_2009 refinery valvesNSPS) under 40 CFR 60, Subpart VV. ...
Untitled Document INTRODUCTION Fugitive emissions from process equipment such as valves, connectors, pumps, etc. can account for 30 to 60% of a petroleum refinery's total air emissions (1). ...
Fugitive emissions occur from valves, pumps, compressors, pressure relief valves, flanges, connectors and other piping components. ...