Refine by
Separator Calculation Articles & Analysis
13 articles found
Summary A former spill site in the United States has three Soil Sensor locations within ~1 metre of each other. Though they are installed in separate boreholes, they are meant to reflect a gradient in gaseous emissions within the soil. ...
ByLiORA
Designing an industrial gantry crane requires more than calculating rated lifting capacity, mechanical performance, or structural strength. ...
The scheme then splits the detected analyzable region of interest into two red and green color spaces which is also followed by application of a scanning algorithm to detect the CEP17 green and HER2/neu red FISH signals separately. Finally, the proposed method calculates the ratio between independent green and red FISH signals of all analyzable cells identified ...
A new decentralised settling system based on the principle of lamella separation was developed for the treatment of road runoff. Two different laboratory test methods, the DIBt (Deutsches Institut für Bautechnik) procedure and our own approach, were applied in order to evaluate the efficiency of the system based on the separation of fine mineral particles and ...
Multi-core computers have more than one processing unit, or CPU, on a computer chip. Each core can be viewed as a separate computer capable of performing independent calculations. By utilizing the BRMS to process the numerically intensive algorithms and data often associated with AERMOD, modelers save time and money. ...
Selectivity coefficients KNO3−Cl−, K2Cl−SO42− and K2NO3−SO42−, thermodynamic constants, and separation factors were calculated and decreased with the increase of ionic strength. ...
Thus, water management of rice paddies is important and was calculated separately using a paddy model. The use of groundwater for rice paddy irrigation was considered as well as a water supply from outside of the watershed (Kasumigaura Lake). ...
Various rate and accumulative exergy components are identified and calculated separately with crank position for various loads. The results show that when the load increases from 25% to full load in steps by 25%, the percentage of combustion irreversibility decreases from 33.7% to 25% of fuel burn exergy. ...
The water quality model integrates two sub-processes: pollutants build-up and pollutants wash-off. The model calculates separate build-up and wash-off from pervious and impervious catchment surfaces. Rainfall and water quality data were collected for the Hotham creek catchment in Gold Coast, Australia. Runoff calculations from hydrologic model ...
In this paper, the impact of nitrates discharged as baseflow on stream water quality were studied using PULSE, a hydrograph separation software developed by USGS, to calculate the monthly baseflow discharge. ...
The growth engine of AquaCrop is water-driven, in that transpiration is calculated first and translated into biomass using a conservative, crop-specific parameter: the biomass water productivity, normalized for atmospheric evaporative demand and air CO2 concentration. ...
The two components of the entropy generation, i.e., friction entropy generation and heat-transfer entropy generation, were calculated separately, compared to each other, and the total entropy generation was calculated. ...
Yields were measured each year and crop yield variability was estimated using the coefficient of variation calculated separately for each crop phase. Averaged over the study period, yields in the CT and NT systems were similar across all crop phases of the rotation and of higher magnitude than the LI system only in the winter wheat phase of the rotation. ...