Sludge Disintegrator Articles & Analysis
23 articles found
Understanding Oil Sludge: A Menace in the Industrial Tapestry Oil sludge, a by-product of various industrial processes, embodies a complex amalgamation of oil, water, and solid residues. ...
This research focuses on the effects of microwave-assisted activated carbon fibre (ACF) (MW-ACF) treatment on sewage sludge at alkaline pH. The disintegration and biodegradability of sewage sludge were studied. It was found that the MW-ACF process at alkaline pH provided a rapid and efficient process to disrupt the microbial cells in the ...
To improve the excess sludge disintegration efficiency, reduce the sludge disintegration cost, and increase sludge biodegradability, a combined pretreatment of anaerobic hydrolysis (AH) and ultrasonic treatment (UT) was proposed for excess sludge. Results showed that AH had an advantage in ...
After the disintegration stage, the treated sludge was returned to the biological reactor. Three different percentages (50, 75 and 100%) of the return sludge flow rate were subjected to disintegration and the effects on the sludge production and the WWTP operation efficiency evaluated. ...
To accelerate this process, alkaline sludge disintegration was tested as a pretreatment method for anaerobic digestion of high-solids sludge. The results showed that alkaline treatment effectively disintegrated both low-solids sludge and high-solids sludge, and treatment duration of 30 min was ...
Abstract Digestion of sewage sludge normally takes place at pH values between 7,0 and 7,5. Control methods of the process stability are based on practical experience such as the ratio of volatile fatty acids (VFA) and total alkalinity (TA). Thermal sludge disintegration for an enhanced digestion process allows a digester feed with higher dry ...
The effect of sludge freezing/thawing on its disintegration and subsequent use as substrate in a microbial fuel cell (MFC) was investigated to enhance organic matter degradation and electricity generation. Experimental results indicated that long freezing time (more than 48 h) was effective in disintegrating the sludge ...
Increasing environmental awareness worldwide and subsequent regulations have led to the application of improved and novel technologies in excess sludge treatment. Sludge is the by–product of wastewater treatment plants rich in organic carbons, pathogens and metals. To enhance the ultrasonic sludge disintegration, a new method by ...
Separate ultrasonic treatment suggested that input power of 0.4 W/mL and ultrasonic time of 10 min were the optimal conditions for sludge disintegration, and the efficiency was reduced with the increase of sludge mixed liquor suspended solids. Separate Fenton treatment revealed that 9 g/L and 40 mg/L were the optimal dosages of H2O2 and ...
In the present study an attempt has been made to recover phosphorus in the presence of poly P and to disintegrate sludge through combinative treatment. Primarily the sludge was treated by thermal method at a temperature range of 40° to 90°C. During thermal treatment, enhanced biological phosphorous removal (EBPR) sludge releases ...
Many drivers tend to foster the development of renewable energy production in wastewater treatment plants as many expectations rely upon energy recovery from sewage sludge, for example through biogas use. This paper is focused on the assessment of grease waste (GW) as an adequate substrate for co-digestion with municipal sludge, as it has a methane potential of ...
Three anaerobic–aerobic cyclic activated sludge processes: one without sludge disintegration; one disintegrated sludge by ozonation; and the other disintegrated sludge with the vibrating ball mill were compared. Ozonation achieved the best sludge reduction ...
The technologies investigated include conventional WWT (reference), ozonation, sand filtration, PAC addition, anammox, sludge incineration (reference), other sludge inertization technologies (wet oxidation, high temperature pyrolysis, gasification) and sludge triage (including sludge disintegration technologies, ...
Sludge is a by-product of wastewater treatment and contains multitude of pollutants. In the present study, irradiation with ultrasound as treatment technique was carried out to treat complex effluent paper sludge, sugar sludge and sewage sludge samples from different industrial places. ...
Ultrasonic sludge disintegration –one of the most commonly used mechanical pretreatment methods- enables the occurrence of cavitation bubbles for the break-up of microorganism cells to extract intracellular materials. ...
Organic micro-pollutants accumulate to a certain extent in sewage sludge and are therefore ecologically relevant if the sludge is to be reused in both agriculture and landscaping applications. ...
Both ultrasonic and alkaline pretreatment of excess sewage sludge were investigated to enhance organic degradation and electricity generation from sludge by the subsequent microbial fuel cell (MFC). The ultrasonic pretreatment showed that the degree of sludge disintegration was directly related to the energy input, ultrasonic ...
The use of ultrasound as pre-treatment to improve anaerobic digestion of secondary sludge has been established as a promising technology. There are great differences between lab scale and full-scale devices, regarding the relationship between the disintegration achieved and the energy supplied. ...
ABSTRACT Sludge disposal in Europe is affected by international trends and legislation, national and local situations, and of course economics. Some important trends are: Safe utilization of organic material and nutrients in the agriculture Sensitivity to energy costs Disinfection, especially by requiring batch heat treatment Restrictions and increased costs for landfill and incineration ...
ABSTRACT The first full-scale plant for sludge disintegration through Cambi thermal hydrolysis was started up in Hamar, Norway at the end of 1995. It is the first plant with a new design where sludge is directly heated by live steam. During the last 3 years the plant worked with an availability of over 99 %. Prior to hydrolysis the ...
