Refine by
Source Emissions Testing Articles & Analysis
13 articles found
The capabilities of Gasboard-9805 align well with current and future requirements for motorcycle emissions testing in Vietnam. Gasboard-9805 incorporates a sophisticated modular design featuring three selectable PEMS components complemented by an integral exhaust flow measurement (EFM) module. ...
The capabilities of Gasboard-9805 align well with current and future requirements for motorcycle emissions testing in Vietnam. Gasboard-9805 incorporates a sophisticated modular design featuring three selectable PEMS components complemented by an integral exhaust flow measurement (EFM) module. ...
Authorities commonly require source-specific emissions inventories, stack test reports, and guaranteed particulate and gaseous limits. ...
ByMacroad
Emissions standards compliance verification requires highly precise, reliable measurement equipment capable of detecting the full spectrum of regulated pollutants across various test conditions. Cubic Instruments, a leading manufacturer of advanced gas sensors and gas analyzers with nearly two decades of expertise in automotive emissions ...
With its wide measurement range, Gasboard-9801 excels in all laboratory testing scenarios by direct or dilution sampling with constant volume sampler (CVS), from standard emissions testing to ultra-low emission applications. ...
The direct link to the EPA site is: An operator who uses a device listed as “YES” is exempt from conducting performance/source emission tests under 40CFR 60.5413(a)(7), 63.772(e) and/or 63.1282(d), and from submitting test results under 40CFR 605413(e)(6), 63.775(d)(1)(ii) and/or 63.1285(d)(1)(ii), as applicable. ...
Last week, Antea Group had the unique opportunity to perform a RATA (relative accuracy test audit) of the emissions from a thermal oxidizer at an ethanol production facility located in Minnesota using a state-of-the-art mobile testing laboratory. ...
We have reviewed 2012 EPA Part 75 test reports and discussed EPA’s electronic reporting and source tester requirements with Part 75 source owners. We conclude that many owners and environmental specialists who enter test data into EPA data bases are not familiar with the range of EPA’s expectations for ...
Bone samples measuring 60 mm long, 22 mm wide and 5.5 mm thick were harvested from bovine femora. Artificial acoustic emission sources were created on the bone samples. The known location of these acoustic emission sources and the recorded arrival times at four acoustic emission sensors were used to develop ...
Because industry provided additional emissions and fuel data for combustion sources, EPA re-evaluated all emissions limits previously proposed for new and existing CISWI units. ...
EPA is preparing to establish new MACT standards under CAA Section 112 for boilers and Section 129 for CISWI units and recently sent Information Collection Request (ICR) letters, pursuant to authority granted to them by Section 114 of the CAA, to a number of sources that operate boilers and potential CISWI units requiring that the sources perform ...
Fence line monitoring- or monitoring in a neighborhood near the perimeter of a metals emission source, offers the potential to not only greatly increase the accuracy of estimating the local impact of fugitive metal emissions, but also has the potential to eliminate the need for costly monitoring of poorly defined emissions from ...
The development efforts in 2004 and 2005 coupled with lessons learned from operation aboard Carnival’s cruise ship have resulted in the identification of additional process and design improvements. Source emission testing by an independent laboratory has also demonstrated that the PAWDS easily meets IMO MARPOL requirements for the ...