clean-air-reference Downloads
6 downloads found
The Clean Air Pitot Probe is utilized to measure air velocity, pressure, and temperature within a flow stream. It uses a standard S-Type pitot probe to measure velocity and thus can follow EPA Method 2 test procedures. The probe is connected to a pressure gauge or electronic pressure transducer to measure the differential. A wind tunnel calibration is necessary in order to determine the ...
Calibration is the process of setting the instrument up to read accurately when exposed to the target gas. The Zero function sets the clean air reference point and the Span function sets the sensitivity of the instrument. ...
This is a two step process. A Low Calibration sets clean air reference point and the High Calibration function sets the sensitivity of the instrument. ...
AM-5175 312-1256 S/W X.X 20.9% 0ppm 20.9W 0ppW 0ppC 20.9C AM-5175 ENMET Corporation 8 4.2 Normal Display Mode When the AM-5175 is installed as described in section 3, and in clean air, the POWER green LED is on, the display is lit and the information on the display in measurement units of ppm detected by the AM-5175. ...
By the selection of different impellers, the fans canalso be used for operation at the clean-air side. For paper processing,Schuko offers a range of specific fans.To reduce sound emission at workplaces and to solve sound insulationquestions concerning the neighbourhood of installations, Schuko cansupply high-grade sound proofing systems. ...
Keep the unit out of the reach ofchildren.• Never douse or squirt the unit with water or any other liquid.Keep handles dry, clean and free from debris. Clean the unitafter each use. Refer to Cleaning and Storage.• Clean the tines with a household cleaner to remove any gumbuildup. ...