concentration-sensor Downloads
176 downloads found
From one to sixteen channels, the GDA-1600 is designed to provide operators the most detailed, real-time information about gas concentrations throughout the facility. Information is relayed via a large LCD that shows real-time gas concentrations, sensor location, sensor type and historical data trends. ...
PSS-800 SS TSS MLSS Sludge Concentration sensor On-line Analyzer water quality tester. PSS-800 SS(Sludge Concentration )Sensor is based on the method of combination of infrared absorption scattered light.Infrared light which the photosource sends out scattered by suspended particles in the sample.And finally converted to ...
Our CO2 gas sensors get a small deviation unlike NDIR Single type. So they keep long term stability. ...
Ethylene sensors are used everywhere where fruit has to be transported and stored. Ethylene (C2H4) is given off into the ambient air by almost all fruits and contributes substantially to fruit ripening when present in the right concentration. Ethylene sensors and CO2 sensors from smartGAS help you in the monitoring and efficient ...
Depending on the requirements of the road traffic meteorological monitoring network, sensors are installed in the roadways and / or "overhead". The Lufft IRS31Pro-UMB is intended for installation in the roadway. The passive measuring instrument IRS31Pro-UMB is used to determine the road surface temperature, the height of the water film above the sensor and the ...
When manufacturing powders, for example dried drinking chocolate, it is common practice to concentrate a liquid before spray drying and this is typically done in an evaporator. The material is then processed through a spray drier where the remaining moisture is evaporated leaving fine particles of powder. Measuring the precise level of concentration of the liquid to identify the point at which ...
ByHydronix
Compatible with over 20 different interchangeable sensor heads, one monitor can be used to measure multiple gases and concentrations. Interchangeable sensor heads also make servicing the monitors as simple as replacing the old head with a new ...
Voltage Output Option 1 Introduction The C1 and C2 sensors have an optional voltage output that is proportional to the averaged CO2 concentration. ...
Widely used, the Alco-Sensor III (ASIII) is a pocket-sized, handheld breath alcohol tester. This NHTSA approved Evidential Breath Alcohol Testing Device provides a simple, accurate and economical method of determining a subject’s breath alcohol concentration. Standard Equipment- Alco-Sensor ...
However, the value we get from the sensors is not exactly representative of the concentration from the sensors is not exactly representative of the concentration value within the sample chamber. ...
OEM module for measuring oxygen concentration using paramagnetic sensor. ...
OEM module for measuring oxygen concentration using Zr02 sensor. ...
Wireless Datalogger with Carbon dioxide sensor (CO2 concentration(max. 9999 ppm)), 4.9MB on-board memory, micro-SD memory slot, USB PC interface, LCD display.Solution with GS-CO2 sensor requires the use of the MicroUSB power cable, and is not recommended with the use of the AA batteries. The compact GL100 datalogger CO2 density ...
.-20 to +50 °C Operating humidity................15 - 90% RH (non-condensing) Pressure range ..................................90 - 110 kPa (nominal) Operating circuit............... see Electrochemical Toxic Sensor Application Note Applied potential ..............................................................0 V Storage life........... 6 months in original packaging (0 - 25 ...
The sensing element of Figaro gas sensors is a tin dioxide (SnO2) semiconductorwhich has low conductivity in clean air. In the presence of a detectable gas, thesensor's conductivity increases depending on the gas concentration in the air. Asimple electrical circuit can convert the change in conductivity to an output signalwhich corresponds to the gas concentration.The TGS 821 has high ...
Expansion card for measuring O2 concentration. This device is equipped with 6 air channels that suck air into the O2 concentration sensor. The electronics placed in the device control the opening of the appropriate valves and the operation of the pump. (valves, pump and sensor are placed in the card). We only bring air ducts (6 pcs.) from places in the installation that we want to measure to the ...
The SM-EC is an electrochemical ozone sensor module for use with our OS-4 or OS-6 digital ozone controller, or as a stand alone module using the RS-232 output. This technology from Eco Sensors provides accurate ppb-level detection and resolution over a wide (.02-20 ppm, or 1-50 ppm) concentration range. The sensor module is compensated for temperature and humidity effects, with little to no cross ...
PMS 20 CONCENTRATION is a sensor module that uses the principle of laser scattering to detect the mass concentration of 4 channel particulate: PM1.0, PM2.5, PM10, TSP in the atmospheric environment. It could be either embedded in an instrument or use directly. The sensor is made with advanced processing chips and light-sensitive elements. After collected, the signals are processed by a ...
Combustible GasMODEL S4000CHFeatures• Compatible with AutomaticRemote Gas Calibrator• Event logging• HART and Modbuscommunication• 4-20 mA output• Warning, Alarm & Fault Relays • Calibration, Calibration Check,Setup Modes• Remaining sensor life indicationBenefits• Fully automatic calibration• Stores fault, gas check, calibration,and alarm event history• Provides complete status ...
The sensor has low conductivity in clean air. In the presence of amine compounds the sensor’s conductivity increases depending on the gas concentration. ...
Bya1-cbiss