microfiltration-membrane Downloads
56 downloads found
Microfiltration (MF) is generally defined as a membrane separation process using membranes with pore sizes between approximately 50 to 10,000 nanometers, a molecular weight cut-off (MWCO) greater than 1,000,000 Daltons and relatively low operating pressures. Materials retained by MF include sand, silt, clays, yeast, algae, and bacteria. Therefore ...
Membranes in microfiltration/ultrafiltration (MF/UF) systems require more frequent cleaning than those in reverse osmosis (RO) systems. ...
Advantages High strength powder formulation specifically designed for use as a high pH cleaner for microfiltration and ultrafiltration membranes Effectively penetrates and lifts biofilms, organic foulants, oils, greases and other hydrocarbons from the membrane surface Disperses inorganic particulates such as silts, clays and metal oxides Designed for use with membranes that are tolerant to ...
The extraordinary chemical resistance property of the membrane material we use in our microfiltration systems allows the use of a wide range of chemicals – acids (H2SO4 or HCl), oxidizers (NaOCl or H2O2), and bases (NaOH) for cleaning off the persistent fouling substances. ...
BioFLOW MF Membrane Skid US Units Membrane Pore Size 0.1 or 0.5 microns Nominal flux 100 – 1,000 gfd Trans Membrane Pressure (TMP) 29 – 116 psig Scouring Velocity 9.8 – 16.4 ft/s Membrane Materials of Construction PVDF membrane on either PE or PVDF substrate The bioFLOW MF ...
PP Microfiltration Membrane Introduction Because of their hydrophobic nature, the polypropylene membranes are best suited for industrial processes such as gas filtration, chemical processes and photo-resist production as well as for application in the automotive industry. Since polypropylene is a pure hydrocarbon material, there are no ...
FiberFlo® TF 1680Hollow Fiber Crossflow FiltrationFiberFlo TF 1680 Cartridges are made using the unique polysulfone hollow fiber membranes available only from Mar Cor Purification. The TF Cartridge is available in a pore size of 0.1µm and 0.05µm, 0.2µm & 0.45µm pore sizes are available for pre-assessment.Dependable Membrane PerformanceThe Hollow Fiber ...
DescriptionPall’s SeptraTM CB Plus microfiltration membrane systemsremove high levels of Giardia, Cryptosporidium and fineparticles from source water. ...
Its use is only justified if it is needed to protect the distribution network.Compactness and modularityUltrafiltration plant is very compact, its height being less than three metres.Its modular design makes it possible to increase production rapidly, and thus to respond quickly and economically to population growth and to increases in consumption.Associated treatmentsFeed water having more ...
Box 634 Huntington Beach, CA 92647 USA Phone: 714-375-6583 - Fax: 714-375-6586 - email: [email protected] Web site – www.lifestreamwater.com Purify Surface water and contaminated well water ? Microfiltration Membranes allow water and dissolved ions, to pass through, but stop suspended solids down to particle sizes as small as 0.1 microns. ? ...
Advantages Concentrated liquid formulation designed for use as a high pH cleaner of ultrafiltration and microfiltration membrane surfaces Works to remove the most stubborn biofilms and organic foulants Especially effective in removal of metal oxide deposits when used in a pH range of 9 - 10.5 Buffered so as not to exceed a pH of 12 Does not cause chemical hydrolysis of polypropylene and ...
Advantages Concentrated liquid formulation designed for use as a high pH cleaner of ultrafiltration and microfiltration membrane surfaces Highly effective at dispersing colloidal clays and other suspended particles Works to remove the most stubborn biofilms and organic foulants Supports the cleaning of acid insoluble sulfates of calcium, barium and strontium as well as calcium fluoride ...
Our state-of-the-art membrane micro-filtration, reverse osmosis and distillation technologies offer reliable, high quality and versatile water reuse ...
The MMS SW18 System is an easy to use batch laboratory membrane device for microfiltration, ultrafiltration, nanofiltration and reverse osmosis ...
Two process steps are critical to the success of a DFMF system operation: (1) chemical pre-treatment to convert the contaminants of concern to filterable particulates and mitigate membrane fouling effects, and (2) physical separation of the particles by membrane microfiltration. ...
LIQUID MEMBRANE CLEANER 8Benefits• Concentrated alkaline cleaner effective on a wide range of organic foulants• Buffered pH to maintain optimum cleaning performance throughout cleaning cycle• Liquid cleaner easily diluted to application strength• Optimal results when used in a program that includes an acid-based Lavasol™or OptiClean™ productUses• ...
For More Information: Call Sterlitech Corporation at (877) 544-4420 or (253) 437-0844, Or visit www.sterlitech.com HP4750 Stirred Cell HP4750 STIRRED CELL The Sterlitech™ HP4750 is a high-pressure, low hold-up volume (1 ml), chemically resistant stir cell that performs a wide variety of membrane separations. FEATURES AND BENEFITS • Safe Operation - ability to safely process ...
A flexible unit for all pressure driven membrane processes: reverse osmosis, nanofiltration, ultrafiltration and microfiltration. Easy change of membrane module: flat-channel or tubular ceramic for screening of membranes and spiral wound modules for larger membrane area and scale-up. Feed vessel with 2.5 or 5 l volume or any external feed vessel, big enough for all lab ...
Standard Features Low Pressure RO membranes skid mounted. Ultrafiltration (U850) PAN membranes skid mounted. Microfiltration cartridges. Feed and High Pressure Pumps . Pressure Gauges, Flow Meters and Manual Valves. ...
Microfiltration is a pressuredriven process where the Trans Membrane Pressures (TMP) are in the order of 1 to 2 bar which is very critical to the performance of the processes. ...
ByGEA