sample-dilutor Downloads
10 downloads found
These autosamplers are ideal for a wide range of analytical techniques including AA, ICP, ICP-MS, TOC, UV-VIS, fraction collection, liquid handling, and more.CETAC.COM || [email protected] || PHONE 402.733-2829 || TOLL-FREE 800.369.2822 || FAX 402.733.5292SIMPLE Easy Set-Up and Operation: Out-of-the-box set-up allows a fully operational system the day of delivery.Internet Accessible Firmware: ...
The Model 108 Heated Sample Diluter dilutes an introduced sample gas of high concentration at a dilution ratio of 1:10 (standard) or 1:100 (optional) to allow linear measurement of total hydrocarbon concentration ratios greater than tens of thousands of ppm, up to 10% and higher. For faster response, greater range and zero stability, sample injection is the method of choice in this proven heated ...
COMMUNICATIONS RACK OPTIONSASX-500 SERIES OEM PLATFORMASX-500 SERIES AUTOSAMPLER PLATFORMThe ASX-500 platform is available configured for fraction collection.Accommodates multiple syringe pumps and a wide range of available syringes with volumes from 12.5 µl to 25 mL.TECHNOLOGY THAT FITSWide selection of sample probes from which to choose, including Teflon® encapsulated carbon ...
520nm x 22.76 x dilution factor mg/l)1/ The syringe pump of the dilutor sips 9.9ml HCl (stock tank) then 0.1ml wine (Racks 1 or 2) 2/ The syringe pump flushes out HCl and wine (racks 3 and 4)• CETAC software controls the dilution8With dilution/addition (2)• With addition of a reactive – sample with a reactive• Addition: the reactive volume is much smaller than ...
When integrated withFIA or as a standalone instrument, the ICoption adds the power to profile samples for a class of ionicspecies. While FIA is ideally suited for processing relativelylarge numbers of samples for a single analyte per injection, ionchromatography enables the determination of multiple ionsfrom a single injection.• Operation of FIA and IC ...
The sample list can be imported from any LIMS system and can be exported to a sample list for post processing of analytical data. ...
By improving the efficiency of sample introduction and removal from the system, more samples can be analysed in less time. ...
Cycle times of 20-30 seconds from inject to inject ensure compatibility with LC-MS and FIA-MS.4PAL HTC-xt equipped with 1 Stack Cooler and Fast washHTC-xtPrep and Load Platform5PAL HTC-xt equipped with 3 valvesPAL HTC-xt equipped with Sample Tray for 98 2ml vials High-Throughput model in 80cm length4-valve operation for parallel or staggered sample analysis2- or ...
Cycle times of 20-30 seconds from inject to inject ensure compatibility with LC-MS and FIA-MS.4PAL HTC-xt equipped with 1 Stack Cooler and Fast washHTC-xtPrep and Load Platform5PAL HTC-xt equipped with 3 valvesPAL HTC-xt equipped with Sample Tray for 98 2ml vials High-Throughput model in 80cm length4-valve operation for parallel or staggered sample analysis2- or ...
The MHE technique requires a series of sampling cycles using the same vial. First, a sample is pressurized to a specific pressure. ...