- Home
- Applications
- liquid phase separation
Refine by
Liquid Phase Separation Product Applications
15 applications found
Sludge dewatering is the separation of a liquid and solid phase whereby, generally, the least possible residual moisture is required in the solid phase and the lowest possible solid particle residues are required in the separated liquid phase ("the centrate"). A typical example of this type of two-phase separation is the dewatering of sludge from municipal sewage ...
ByHiller Separation and Process based in Lampasas, TEXAS (USA)
PROCESS INFORMATION: The Vacuum Unit is fed with Crude Bottoms and is injected with steam. Passing upwards through wash oil stages, the gas exits to an overhead condenser, where cleaned gas goes to LT Ends, and Naphtha and Light Cycle Oil are produced as liquids. From side streams the Vacuum Unit sends HVGO to the FCC Fractionator and LVGO to the Hydrocracker or for ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
PROCESS INFORMATION: The Fractionator is fed from the reactor and side strippers are injected with steam. Naphtha and Light Cycle Oil are produced. In a Pipestill, fed from a crude furnace, the side strippers produce Jet A, Gas Oil and Diesel or Heavy Gas ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
PROCESS INFORMATION: In (UOP) Merox Units, where crudes are acidic, Caustic is used to reduce H2S traces and the Mercaptan Sulphur content. Caustic Treating Systems are done with a Pre-Washer followed by a Reactor vessel. The mixture is then fed to a liquid-liquid separator to remove the water and caustic from the ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
Air or SO2 is dried with H2SO4 before being fed to the sulphur burner or converter. The Drying Tower can be under pressure or under suction, with the main gas blower being, respectively, in front of or after the tower. The physical limit of drying is 3 mg/SCF of gas as H2O (= 16 mg/SCF as H2SO4) Large particles (>3 microns) are mechanically entrained from the acid distribution system or packing, typically as a load of 500 – 750 mg/m3. As the Drying Tower operates at relatively low temperature, mist is ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
METTLER TOLEDO/INGOLD solutions cover a wide range of process conditions found in chemical processes. Our products master even most demanding chemical environments with high temperature and pressure - the industry proven design ensures high safety and reliability. Certificates as ATEX, FM, CSA, 3.1B are available with our products to comply with plant safety requirements. Our application solutions can be integrated into plant wide process control and asset management ...
ByMettler - Toledo Int. Inc based in Greifensee, SWITZERLAND
We are proud to be an associate member of both Growth Energy and the Renewable Fuels Association. These organizations advocate on behalf of America’s biorefiners, who are transforming widely available crops into sustainable fuels for cars, ships, trains, trucks, and planes. Please click on the icons below for more ...
BySeparator Technology Solutions (STS) based in San Leandro, CALIFORNIA (USA)
PROCESS INFORMATION: The Amine gas treating, also known as gas sweetening, refers to a process that uses aqueous solutions of various alkylamines (commonly known as amines) to remove hydrogen sulphide (H2S) and carbon dioxide (CO2) from gases. Aqueous solutions of MEA (monoethanolamine) are used as a gas stream scrubbing liquid in amine treaters to remove H2S from sour natural gas. The MEA reacts with acidic compounds dissolved in the solution, using a large surface area to contact with the cold scrubbing solution ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
PROCESS INFORMATION: The Naptha Hydrotreater prepares feedstock for downstream reforming or isomerization. The naphtha feed is mixed with hydrogen rich recycle gas. The mixed feed is then heated and then fed to the reactor, which contains a cobalt-molybdenum or nickel-molybdenum catalyst to convert contaminants such as sulphur, nitrogen, oxygenates and halides to hydrogen sulphide, ammonia, water and hydrogen halides. These can then be removed from the hydrocarbon stream. ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
CL Solutions provides a special consortium of microbes for remediation of wastewater containing high concentrations of used or waste ...
ByCL Solutions, LLC based in Norwood, OHIO (USA)
CST’s Turbidimeter continuously and accurately measures turbidity using NIR spectroscopy. Turbidity measurements are important indicators in many industries and applications as they not only influence the yield of the industrial process, but also detect factors which are detrimental to a system. The Turbidimeter consists of a PX2+ used in conjunction with either an extractive flow cell or in situ transmission ...
ByCustom Sensors & Technology (CST) based in Fenton, MISSOURI (USA)
Fuel Gas Streams are frequently contaminated with liquid aerosols. The liquid exists as a stable and persistent “smoke” in the gas stream. The liquid contaminant can enter the gas stream through any one of a variety of events including – phase separation and condensation, compressor lube-oils from compression, chemical addition to pipelines (including corrosion inhibitors), and entrainment from overheads of ...
ByPentair Filtration Solutions, LLC based in Conroe, TEXAS (USA)
On-the-spot measurement of total microorganisms! fuel1Microbial growth in liquid hydrocarbon fuels and lubricants presents a major problem. Storage tanks, delivery systems, and filters can become fouled through microbial proliferation and metabolic activity, which results in a myriad of problems, including reduced product quality, storage system corrosion, and filter plugging. The best solution to this problem is early detection and ...
ByLuminUltra Technologies Ltd. based in Fredericton, NEW BRUNSWICK (CANADA)
Evaporation is a proven and effective way of reducing the volume of many waste streams. HRS Heat Exchangers offer solutions for the evaporation and concentration of waste streams from a wide variety of industries, such as water treatment, bioenergy and food production. A common issue when treating certain waste streams with standard evaporation technologies (such as falling film) is that when heated, they can foul equipment. As the concentration of solids increases during the evaporation process, so does the risk ...
ByHRS Heat Exchangers Ltd. based in Watford, UNITED KINGDOM
Hiller DecaFood machines provide world-class standards for high-performance decanter centrifuges and the modern range of Hiller DecaFood Decanter Centrifuges reflects our ongoing commitment to mechanical development and process optimization for a wide variety of food processing technologies. Applications such as fruit and vegetable juices, spice extraction, wine, grape must production or dregs processing are only some of the examples where the DecaFood system can be applied. As our customer you benefit ...
ByHiller Separation and Process based in Lampasas, TEXAS (USA)