- Home
- Applications
- italy
- filter paper
Show results for
Refine by
Filter Paper Product Applications In Italy
13 applications found
This method for the measurement of sodium and potassium in silicate rocks uses a borate fusion ...
ByBWB Technologies Ltd. based in Newbury, UNITED KINGDOM
This procedure uses a TCA (trichloroacetic acid) extraction of the tissue to release all of the ...
ByBWB Technologies Ltd. based in Newbury, UNITED KINGDOM
This method reduces or removes potential interference from sodium, potassium and phosphates normally present in serum and urine by diluting the samples with a diluent containing ethylenediaminetetraacetic acid ...
ByBWB Technologies Ltd. based in Newbury, UNITED KINGDOM
The most important ions which naturally occur in plant tissues are sodium, potassium, calcium, magnesium, nitrate, sulphate and phosphate. A sample of 5 g of oven-dried plant material contains on average, 25 mg calcium, 9 mg magnesium, 80 mg potassium and 3 mg sodium. The recommended method for the measurement of calcium is to precipitate the calcium as an oxalate, the precipitate is then dissolved and measurement taken from the resulting solution. Sodium and potassium may be measured directly following an ashing ...
ByBWB Technologies Ltd. based in Newbury, UNITED KINGDOM
Cheese was wet ashed with a combination of acid and a high temperature oven to form a dissolvable product ready for analysis via flame ...
ByBWB Technologies Ltd. based in Newbury, UNITED KINGDOM
Several different techniques can be used for sample digestion and extraction of sodium and/or potassium: oven ashing, perchloric acid ashing, extraction by boiling and acidification with HNO3 as well as extraction by homogenisation in 2% trichloroacetic acid (TCA). ...
ByBWB Technologies Ltd. based in Newbury, UNITED KINGDOM
Commercial cereals vary considerably in composition, both in their formulation and the ingredients added to enrich these products. Sodium is the predominant cation in breakfast cereals, at levels reaching 8mg/g. Potassium and calcium also vary, particularly in wheat-based products and those enriched with milk products or calcium salts. ...
ByBWB Technologies Ltd. based in Newbury, UNITED KINGDOM
Principle: Potassium was extracted from a soil sample with acidified ammonium lactate to determine plant available potassium ionic concentration present in the ...
ByBWB Technologies Ltd. based in Newbury, UNITED KINGDOM
A number of methods have been reported for the measurement of calcium in biological materials by flame photometry or titration. This method employs trichloroacetic acid (TCA) to precipitate the proteins and has been found to be adequate to extract all of the calcium from tissue samples. Sodium, potassium and phosphate caused no significant interference and calcium concentration in the range of 0 to 2 µg/ml is readily determined. ...
ByBWB Technologies Ltd. based in Newbury, UNITED KINGDOM
The effect of potential interference from other constituents of sea water was studied, including sodium, chloride and potassium. It was found that pre-concentration of the sea water was not necessary prior to analysis. A filtration of the sample was only necessary if sample contained suspended material. ...
ByBWB Technologies Ltd. based in Newbury, UNITED KINGDOM
Dried milk was dissolved into an aqueous solution for analysis via flame photometry. The test solutions and reference solutions are measured directly following dilution with deionised distilled ...
ByBWB Technologies Ltd. based in Newbury, UNITED KINGDOM
In most cases, it was found that flame photometry was well suited for the determination of sodium, potassium and calcium in fresh fruits, using the wet ashing technique as given below. There are significant differences in the composition between different varieties of the same fruit, although these differences are not usually considered to be nutritionally ...
ByBWB Technologies Ltd. based in Newbury, UNITED KINGDOM
A wide range of sample acquisition and filtration systems are available to prepare even the most difficult of samples for reliable on-line analyser measurement. The correct choice is often critical to prevent analyser blockage and optimise performance. Cross Flow Filtration The PPM cross flow filter, is a simple in-line device used to protect an analyser from ingress of solids, for applications where sample quality is generally good but occasionally suspended solids may be present. The stainless steel filter ...
ByPollution & Process Monitoring Ltd based in Sevenoaks, UNITED KINGDOM