Refine by
Effluent Cod Articles & Analysis
128 articles found
The facility is a rendering plant, utilizing a limited waste water system. The basic design has a cooling tower, from which the water passes through a grease trap and then into an aeration tower. The water is then discharged into a series of three small lagoons, with a retention time that is calculated to be between 10 and 15 days based on a system volume of 110,000 gallons in the tanks and ...
This Coca Cola bottling plant added a new bottling line that doubled its production that, in turn, doubled the organic loading to its activated sludge waste treatment ...
Location: Polymer Manufacturer, Texas Background: A water-soluble polymer manufacturer was having difficulty with an activated sludge treatment system that failed to meet permit limits. The treatment system was designed with an initial flocculation phase, whereby the pH was adjusted to 12 or above, followed by an anaerobic treatment phase, which discharged to a typical aerobic activated sludge ...
The facility looked to Real Tech to help achieve these goals, installing an industrial grade, real-time BOD/COD probe on the effluent of their production plant. The wastewater probe delivered reliable and continuous COD, cream and protein data, in addition to event notification. ...
The required aeration rate of a biological treatment system is determined by three key parameters: incoming organic loading expressed in terms of COD or BOD, dissolved oxygen (DO) concentration maintained in the aeration tank, and the concentration of microorganisms maintained in the aeration tank expressed as MLSS. ...
Monitoring organic loading ,via rapid or real-time BOD/COD measurement, early in the municipal wastewater treatment process empowers you to: Detect and identify industrial discharge events Optimize chemical addition for incoming wastewater COD/BOD, decreasing the potential for under- or overdosing Improve clarifier performance, increasing sludge quality and ...
The Project Smart Storm designed a complete, bespoke effluent treatment system to address the 'consent to discharge' parameters, ensuring the new Brewery was discharging within the consent to discharge limits:- Lamellar clarifier to drop out solids and to comply with consent limits (1) pH balancing with acid and caustic for optimal Bio Augmentation (2 & 3) Bio ...
After membrane filtration, Ozone Capacityis added for disinfection, decolorization and degrade COD. Treatment Capacity: 230,000 t/d Influent Quality Index (COD): 40-50mg/L Effluent Quality Index (COD): 20mg/L Influent ADMI: 30 Effluent ADMI: <10 Influent cfu/L: 200,000-300,000 ...
After advanced treatment, degrade COD in the water, deodorize, decolorize, sterilize and disinfect. Treatment Capacity: 400,000 t/d Influent Quality Index (COD): 60-80mg/L Effluent Quality Index (COD): 3mg/L Influent cfu/L: 5000-8000 Effluent cfu/L: 0 Ozone Capacity: 35KG/H Completion: Sep.2016 ...
The design treatment capacity is 250m3/d, with an operating capacity of 90%. Designed influent/effluent water quality index Influent water quality SS≤10mg/L, Conductivity≤20000 us/cm, NH3-H≤1100 mg/L, TN≤1450 mg/L, COD≤12000 mg/L, BOD≤3500 mg/L, Total Hardness（CaCO3）≤1000 mg/L, Total Alkalinlity（CaCO3）≤5000 mg/L, SiO2≤30 mg/L, ...
Capacity: 200tons/day (Double stage DTRO) Discharge standard: COD<=25000mg/L, BOD<=10000mg/L,SS<=400mg/L, pH 6-9, NH3-N<=2500mg/L, TN<=3000mg/L, Conductivity<=35000mg/L, Temperature 5-35 Effluent water quality: COD<=100mg/L, BOD<=30mg/L,SS<=30mg/L, NH3-N<=25mg/L, TN<=40mg/L We are a specialist in the ...
According to my observation, the return system of the second settling tank is normal, and the sludge sedimentation in the second settling tank is basically returned). The COD of the inlet water is not very high. The COD of the secondary effluent is below 60mg/l (should be very good), and the entire biochemical system is very normal. ...
In the current commissioning stage, the sewage inflow is 100M3/h, the COD is 50mg/l, and the water temperature is about 15 degrees. Answer: 1. ...
As you can see in the process flow diagram , the plant consists of two parallel nitrification-denitrification lines that receive effluent from the existing DAF systems. A clarification tank was installed downstream, before the point of discharge. ...
The sludge load of the aerobic tank is too high (the effluent is turbid, the COD is high, the sludge is finely crushed after the sedimentation of the aerobic tank and the supernatant is turbid). The sludge load of the aerobic tank is too low, the aeration is excessive, and the finely divided sludge produced after the sludge is oxidized (the COD ...
Capacity: 300m³/day Influent water quality: COD≤ 10300mg/L NH3-N≤2850mg/L Conductivity≤ 38300us/cm Total Hardness(CaCO3)≤ 17000mg/L Total Alkalinlity(CaCO3)≤ 4734.3mg/L SS≤ 1745mg/L PH 6-9 Effluent water quality/Discharge standard: COD≤ 100mg/L NH3-N≤25mg/L SS≤ 10mg/L Features Mobile standard ...
Influent water quality SS≤10mg/L, Conductivity≤20000 us/cm, NH3-H≤1100 mg/L, TN≤1450 mg/L, COD≤12000 mg/L, BOD≤3500 mg/L, Total Hardness（CaCO3）≤1000 mg/L, Total Alkalinlity（CaCO3）≤5000 mg/L, SiO2≤30 mg/L, Sulfide≤3 mg/L, T 15-35℃, pH 6-9 Effluent water quality COD≤20 ...
Project location: Shaoyang City, Hunan Province Project scale: 400 tons/day Operation mode: Jiarong invests equipment and provides equipment installation, commissioning and professional operation services, charging per ton of water service Treatment process: two-stage DTRO (two sets of 200 tons/day containerized leachate treatment equipment) Discharge standard: Table 2 standard of "Pollution ...
Capacity: 300m³/d Process: Containerized Leachate Treatment Equipment, 2 stages of DTRO Influent water quality: NH4+-N≤2500mg/L, TN≤3000mg/L, COD≤10000mg/L Effluent water quality meets the discharge standard. ...
These items will vary plant to plant, depending on processes, but typically include: Comprehensive water use data from most plant areas Energy usage Key waste plant data Influent-effluent flow, TSS, COD, FOG, TKN, chemical use rates, biological system health, ‘Quat’ use data City water billing, rates and upcharges Product loss ...