Refine by
Stack Gas Services
23 services found
by:Beta Analytic Inc. based inMiami, FLORIDA (USA)
ASTM D6866 is a standard method employing radiocarbon dating techniques to determine the percentage of “recently fixed carbon” (biogenic fraction) versus “old carbon” (non-biogenic fraction from fossil sources) present in a solid fuel or its stack gas emission. Materials in fuels (municipal solid waste, used tires, sewage sludge, ...
Manufactured by:Mechanical Systems, Inc. (MSI) based inSun Prairie, WISCONSIN (USA)
Mechanical Systems, Inc., engineered and installed a continuous emissions monitoring system (CEMS) for a wood-fired, steam-generating boiler. For this project, using a continuous opacity monitoring system (COMS) was not possible because of wet stack gas, so the BetaGuard Particulate Monitor provided a better solution for this ...
by:Bhagwati Enviro Care PVT. LTD based inAhmedabad, INDIA
We have highly qualified, trained and experienced personnel working in our well–furnished Laboratory with sophisticated equipment such as Gas Chromatograph (ECD, NPD, FID), Atomic Absorption Spectroscopy, Flame Photo meter, Spectrophotometer, PM2.5 & PM10 Samplers, High Volume Air Samplers, and Stack Gas Monitoring Kits. The Laboratory ...
by:The McIlvaine Company based inNothfield, ILLINOIS (USA)
Mercury Air Reduction Markets provides forecasts for consumables and capital equipment to reduce mercury emissions from stack gas discharges. This world wide report and database is continually updated to reflect forecast changes for coal fired boilers, incinerators, and other sources of emissions. The U.S. utility forecasts are based on specific assessment of ...
Manufactured by:Automatic Flare Systems Limited (AFS) based inCoventry, UNITED KINGDOM
We offer a full range of procedures for the monitoring of flare stack and gas engine emissions. Our engineers are equipped with advanced portable emissions analysers, which are lightweight and give a very high degree of ...
by:SPES DESIGN srl based inBucharest, ROMANIA
Structural design and detailed fabrication/erection drawings for Steel Structures: - Power plant structures (Boilers, Heat recovery steam generator systems, Stacks) - Oil and gas structures (Pipe racks, Shelters, Derrick supported flares) - Cement industry structures ( Conveyor structures, Silo structures and supports) - Commercial and industrial ...
by:ALS Environmental based inHouston, TEXAS (USA)
At ALS Environmental, we provide a full range of environmental analytical testing services, specializing in the analysis of soil, sediment, water (raw, waste, drinking, catchment, recycled, saline, product), leachates, dust, air (indoor, stack, ambient), gas, biota, industrial hygiene, and radiochemistry. Analytical laboratory testing services for these matrices ...
by:ALS Global (Australian Laboratory Services) based inAustralian Capital Territory, AUSTRALIA
At ALS Environmental, we provide a full range of environmental analytical testing services, specializing in the analysis of soil, sediment, water (raw, waste, drinking, catchment, recycled, saline, product), leachates, dust, air (indoor, stack, ambient), gas, biota, industrial hygiene, and radiochemistry. Analytical laboratory testing services for these matrices ...
Manufactured by:The MART Corporation based inMaryland Heights, MONTANA (USA)
If heat source is natural gas or propane, local or independent gas company will check operating parameters of gas burner to ensure compliance with local codes including combustion, flue gas analysis, stack temperature reading, and incoming primary and secondary gas pressure, and adjust operation ...
Manufactured by:P S Analytical Limited based inOrpington, UNITED KINGDOM
Contract Analysis and Special Projects: In house analysis of client’s samples is undertaken on a regular basis. The laboratory at PSA is equipped to carry out elemental determination and speciation utilizing the following ...
by:Source Evaluation Society (SES) based inResearch Triangle Pa, NORTH CAROLINA (USA)
The Source Evaluation Society QSTI/QSTO Committee has developed general requirements for applicants for the SES QSTI/QSTO ...
by:Infraspect based inPortsmouth, NEW HAMPSHIRE (USA)
Locates Problem Areas on the Exterior as Well as Loss of Metallic Area Inside the Steel. Properly inspecting wire ropes with this robotic Non Destructive Testing (NDT) service can: Help to extend their service life, Help the asset manager know when to replace their wire rope, Prevent catastrophic failure, Help prevent business ...
by:Environmental Efficiency based inBray, IRELAND
Air emissions from stacks, bag filters and other air emission points can cause health and nuisance problems not only in the locality but sometimes 10's of km away. Air Dispersion Modelling can predict whether there will be problems with emissions from your site and help explore the effect of various solutions. Environmental Efficiency has a range of Air Dispersion Models including AERMOD at its ...
Manufactured by:Aura-Scientific, LLC based inApex, NORTH CAROLINA (USA)
We have experience with Hg relative accuracy test audits, low mass emitter testing, scrubber performance testing, sorbent injection performance testing, laboratory audits, test plans, project management, method development and beta testing of Hg CEMs and sorbent trap systems. We offer sorbent trap technology customized for your particular needs, from high particulate, high acid ...
Manufactured by:S-Keeper 7 CEMS - a brand by Tecnova HT srl based inPregnana Milanese, ITALY
S-Keeper 7™ Type Approved continuous emissions monitoring system is in compliance with several applicable directive such us Marpol, NOx Technical Code, as already explained. This compliance is proven since the constrains and guidelines were strictly followed during engineering and construction but using the NOx analytical method: our engineering team chose the method that uses the NDIR ...
Manufactured by:Viper Imaging, LLC based inBirmingham, ALABAMA (USA)
Viper Imaging offers both customized and out-of-the-box solutions designed to monitor temperature in processes at industrial complexes and ...
Manufactured by:S-Keeper 7 CEMS - a brand by Tecnova HT srl based inPregnana Milanese, ITALY
MRV is the acronym of Monitoring, Reporting & Verification and it became popular when the “Regulation (EU) 2015/757 of the European Parliament on the Monitoring, Reporting and Verification of Carbon Dioxide emissions from maritime transport” came into force last 1st July 2015. ...
Manufactured by:Chell Instruments Ltd. based inNorth Walsham, UNITED KINGDOM
Chell provide a convenient & viable alternative to theneed to return measuring instruments to a calibrationlaboratory. Customers can benefit from theconvenience of having calibrations performed ontheir plant, dramatically reducing downtime. Onebenefit of this approach is that instruments arecalibrated in their working environment & often intheir working attitude, thus reducing orientation ...
Distributed by:Norditech Pty Ltd based inArndell Park, AUSTRALIA
Public and private industrial operations from mining to landfills are under increasing pressure to control, monitor, and mitigate stack air pollution. The EPA’s Clean Air Regulations set in-stack emissions limits for pollutant concentrations at the point of release, and facility operating licences require emissions monitoring on a continuous basis. Non-compliance with licence requirements ...
by:Odour Monitoring Ireland based inTrim, IRELAND
Hydrogen sulfide (or hydrogen sulphide) is the chemical compound with the formula H2S. This colorless, toxic and flammable gas is responsible for the foul odour of rotten eggs and flatulence. It often results from the bacterial break down of organic matter in the absence of oxygen, such as in swamps and sewers (anaerobic digestion). It also occurs in volcanic gases, natural gas and some well ...